Search: sony
Results: 20088
Make Model Symptom Problem Solution By
SONY AE1C
Field collapse R802 in 27v line o/c due to e-w chip ic1501shorted between 2 pins
SONY AE1C
Excess width e/w distortion tea2031a hot Tea2031a (on j board) and l806
SONY AE1C
Dead with leds flashing C617 100m
SONY AE1C
Dead after poss lightening damage Q604 s/c, r604 hi res, d609 & 619 s/c, d621 o/c, tea2260 leaky between pins 15 & 16 (used tda2261)
SONY AE1C
Dead - chopper tr s/c Replacement got hot - r651 100r sm o/c & c611 47µ was the cause
SONY AE1C
Dead - chopper fet s/c Replace r604 150k & r610 180k & buz91a fet
SONY AE1C
Col flickers to black & white Loss of 5v supply on board b - cct prot to 5v supply o/c
SONY AE1C
Blank raster Q305 dta144ek sm on col dec board b
SONY AE1C
Blank raster Q305 dta144ek on decoder board b
SONY AE1C
4 flashes on front led then nothing Replaced c617 100ufd and c617 220ufd also attend to dry joints on the various regulator ic's
SONY AE-1B KVX2932U
Frame foldover at the top C531 1000uf 50v
SONY AE1B KVX2532U
Int txt & lum (when ae plug wiggled) Dry joints ic pins on txt board
SONY AE1B KVX2532U
Audio lh chan int goes to max with crackle Tda6200 on audio j panel sus. as this chip is expensive, commoned both o/p to good chan
SONY AE-1B KVX2132U
Reduced height R802 0.47r
SONY AE1B KVX2132U
Lines over bright parts of pic & rolling Q598 in video amp circuit faulty, c592 100µ was the cause.
SONY AE1B KV2932U
Line tearing, no sync, vert roll, and colour flickering on/off When link jw105 (cut txt) adjacent to txt board skts on main pcb was linked, fault cleared. ic2 (saa5231) vid t/txt processor ic on the "v" t/txt board was found to be the cause
SONY AE1B
Over bright pic with fb lines D802 rgp10gpkg23 leaky & r805 1r2 hi res
SONY AE-1B
Int pic When off turning up a1 gives pic with no b - b o/p tr q709 dry joint
SONY AE-1B
Bottom foldover/top stretch C531 680µ 25v, c532 100µ 50v
SONY AE1B
St/by only Dry joints audio o/p chip ic261 blew chip tda2050 then destroyed d613/614 (-19v rects)