Search: sony
Results: 20073
Make Model Symptom Problem Solution By
SONY TCWR645S
Very faint pinging sound in backround - moved head wire Very faint pinging sound in background on playback of dolby son b deck. also found that when playing blank tape or running deck withno tape there was a static discharge, ticking sound, with dobly s on oroff. pinging sound was ticking sound being proce
SONY TCWR545
No audio in left channel - replaced lfp101 No left channel on record or playback.
SONY TCK615S
Unit damages tapes, pinch roller unstable The unit exhibits tape path problems due to an unstable pinchroller assy. the center of the shaft the pinch roller rolls on has araised bulge in the center. this bulge causes the pinch roller to wobbleor rock from side to side on the bulge during play or
SONY TADL100
No functions - replaced ph701 Unit has no functions. functions cd1, cd2, tuner est willnot light up when pressed. -solution : ph701 is bad, pin on input signal was strong, pin 4 outputwas very low. changed ph701.
SONY TAAV621
Intermittent protection - replaced c703 On one channel there is +2 to +5 volts on the emmitors ofoutput transistors. this case q713 & q712. checked all resistors,transistors, in channel all checked good. problem seemed to be in areaof q701 replaced it, same problem, found c703 shorted.
SONY STRD915
No power - replaced ic202 Unit won't power up, found no output from pin 38 of ic202for power relay.
SONY STRD515
Dead - replaced output transistors Unit arrived and would not power on.
SONY STRD315
No power - reconnected cnp951 No power.
SONY STRD1015
Hf buzz on all outputs - add 820pf cap btwn ic631 out & gnd High frequency buzz on all outputs at no volume, more noticable when display dim(sleep timer on). found 3mhz modulated with h/f buzz all around the set (including gnd) especially at ouput of ic631. the ic was getting worm
SONY STRD1015
Front and rear distortion - replaced ic631 Only in theatre mode, when all speakers attached, front andrear channels distorted. ic631 drawing excessive current. easy to checkby removing connector cnp620.
SONY MHC1750
Unit goes into demo mode after a minute - this is normal The unit goes into demo mode automatically when all the disc trays are empty if no key is pressed for more than one minute, see page 10 of owner's manual.
SONY MDS302
Unit inoperative - loosened damper screws Three units came in for different reasons but were inoperativeupon arrival. power will not turn on.
SONY LBTG2000
No power display only works - d1301 cold solder Display lit up but unit had no audio or cd functions. found no dc voltages anywhere. main rectified d1301 cold soldered.
SONY LBTD550
No audio - replaced relay ry1201 Unit has no relay channel external spk only, tracked singal to relay ry1201 when relay clicked it was not outputting the right channel.
SONY HCDH605
Missing tray in cd - replaced tray Unit came in with number 5 disc problem. discovered no tray in #5 tray holder. no evidence of previous servicing just wasn't there. -solutioin: replaced tray, set up ok.
SONY HCDG2000
Remote not working - q322 (au bus) on cd main board shorted Remote not working
SONY HCDD560
No cd, reel motor, or focus - resoldered x101 No cd function, no reel motor, sled motor or focus function.will load cd.
SONY HCDD560
Dead unit - replace f1901, ic1351 and ic1201(power amp) Unit came in dead main fuse open and regulator ic burned.
SONY HCDD250
Cannot switch modes System control ic601 part no in the service manualis 875924806. the replacement is 875928891, desc. mpd78042agf012-3b9, inthe mainframe system. the part that kc is shipping is 875932541, desc.mpd78042agf 022 3b9, and is not comparable.
SONY HCDC605
Low or no audio on left channel of deck a - replace ic401 Unit came in with very low audio output on left channel of a deck. rv311 had no effect on output. only in karaoke mode did l cahnnel equalize with r.