Sony Repair Tips
Search: sony
Results: 20105
Results: 20105
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV27S10
|
No picture, replaced r701 | No picture but has sound. found low voltage on g2 pin5 crt socket... found r701 open. | ||
SONY |
KV27FX10
|
No picture sound ok, replaced r542 and d809 | No picture, but sound is ok. | ||
SONY |
KV27EXR25
|
Unit shut down, replaced ic101 | Shut down intermittently. osd had a 60hz bend only osd picture perfect. | ||
SONY |
KV20VM20
|
Tiny hor.line in middleof screen,ic301/pin 7 re-soldered | Tiny horizontal line that split screen in middle.replacing ic1301 didn't hold. found crack on foil connected toic-301/pin 7. | ||
SONY |
KV20VM20
|
No audio, replaced fl401 | No audio signal at the audio input connector p1602/pin 1 onthe d board. nor at the base of q451 on the ma board. audio waspresent at ic401/pin 14 . found filter fl401 located between ic401/pin 14 and the base of q451 was open. | ||
SONY |
KV20S10
|
1/3 of picture is blankout, resoldered flybackpin 8 | Pix 1/3 up screen, no video just raster, bottom 1/3 of pix isblack not scanned on. -solution :replaced ic501, believe vert problem? turned out that 13vwas low, 11v, found out pin 8 of fbt bad joint resoldered pin 8 set ok.do not understand why 13v lin | ||
SONY |
KV20S10
|
Intermittent tuning, replaced tuner | Channels get static then come on. | ||
SONY |
KV20S10
|
Dead, npf, | Dead. | ||
SONY |
KV20S10
|
Picture flips, adj vfre | Picture flips. | ||
SONY |
KV13VM20
|
No picture, replaced crt | No picture, sound ok. | ||
SONY |
KV13TR24
|
Intermittent no picture or snow, replaced leaky d101 | Unit would go to snowy or intermittent picture. | ||
SONY |
KPR46XBR25
|
No video, replaced q1605 on a board | No raster, when g2 was increased on all 3 crts raster appeared with retrace lines and raggedy edges, only when reducing g2 voltage on green crt, video would be visible momentarily. | ||
SONY |
KP61XBR38
|
No vertical sweep, replaced c1713 shorted | Set had no vertical sweep. 3 color lines across center of screen. f902 was blown, sub deflection ic's checked good found 15v missing. ic 905 getting very hot. | ||
SONY |
KP61XBR38
|
No main menu display, replaced ic2301 on e2 board | Could not bring up the main menu. tracked problem to e2 bd. pin 2 of ic2301 was less than 100Ω. | ||
SONY |
KP53XBR35
|
Defocusing of green tube | Picture was poorly focused at high brightness levels.closer examination proved only green crt was defocusing. | ||
SONY |
KP53V15
|
Power supply dead(g bd), repalce t601 | Issued mcb asked servicer to send in old board. they could not find problem after replacing and checking many components. | ||
SONY |
KP46XBR35
|
Set going into protection, replaced q801 on n brd | Protection activated at power on, short on 115 volts line. found q801 shorted emitter to collector. | ||
SONY |
KP46XBR35
|
Thin line on picture, replaced q630 regulator | Intermittent retrace lines. discovered defective transistors on 225v regulator. | ||
SONY |
KP46XBR35
|
No picture, c1713 shorted | Unit had no pix,just lines across screen. | ||
SONY |
KP46V15
|
Smeared green hi-lites, replaced q734 on cg brd shorted | Symptoms were smeared green highlight areas in video, and when set was turned off, a green circular blotch would appear and gradually decay to black. |