Sony Repair Tips
Search: sony
Results: 20102
Results: 20102
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDTR23
|
Int pix; displays all kinds of colors in camera/flex cd137 | In camera section the pix first displayed red pix then blue,green etc. in sequence. found flex cable of ccd imager board is cut, thatcaused problem. | ||
| SONY |
CCDTR23
|
Unit does not record audio / reconnect ma231, mic bd conn | Doesn't record audio (no mic audio) - solution: reconnect flex connector at cn001 on ma231 pc board._hq comments: there is no history of this being a common problem. wewill monitor this for future problems. thanks for the input. | ||
| SONY |
CCDTR21
|
Tape door is inoperative / cn522 on the sl bd split; replace | Cassette compartment would not open or close. foundconnector cn522 on the sl-27 board was split in half, down the side ofpin 1. -hq comments: replace defective connector. part# 169147221 | ||
| SONY |
CCDTR200
|
No video in pb, audio ok / replace l123 in croma trap | No video in pb, audio is ok. | ||
| SONY |
CCDTR101
|
No color in camera / resolder ic301 | Color in pb but not e-e. | ||
| SONY |
CCDTR100
|
No playback pix / replace c1167 on the he19 bd | No playback pix, audio ok. | ||
| SONY |
CCDTR100
|
No audio dislodged au bd from the vs bd. | Found audio board knocked from connector. | ||
| SONY |
CCDSC6
|
Black and white/distorted picture in cam mode ic655/vc bd | Picture was distorted and black and white while unit wasin camera mode | ||
| SONY |
CCDSC5
|
No audio / replace switch block | No e-e audio playback video ok. | ||
| SONY |
CCDFX730V
|
No audio in playback or camera / resolder au bd connector | No audio in playback/rec, pix ok. found cn401 au175 had coldsolder. | ||
| SONY |
CCDFX630
|
Individual motor testing using rm-95 | Models such as the ccdtr400 and ccdfx430 do not include themotor test on one of the service procedures, ex, capstan forward andreverse drum forward and reverse etc. | ||
| SONY |
CCDFX630
|
Horizontal jitter / resolder ic505 | Large h jitter on playback. atf servo appeared to belocked. no mech problems found. | ||
| SONY |
CCDFX630
|
Static line in shadow / replced a to d converter, ic609 | Camera has static line in shadow. | ||
| SONY |
CCDFX630
|
Evf loose / replace screws and lock-tite. | Found viewfinder hanging loose from cabinet and screws looseto bottom unit. | ||
| SONY |
CCDFX620
|
Unit is dead / replace q505 on the cs44 board | Unit dead | ||
| SONY |
CCDFX530
|
Individual motor testing using rm-95 | Models such as the ccdtr400 and ccdfx430 do not include themotor test on one of the service procedures, ex, capstan forward andreverse drum forward and reverse etc. | ||
| SONY |
CCDFX430
|
Individual motor testing using rm-95 | Models such as the ccdtr400 and ccd fx430 do not include the motor test on one of the service procedures, ex, capstan forward andreverse drum forward and reverse etc. | ||
| SONY |
CCDFX420
|
Pb video is dark; hor bands in middle; replace ic704 | The picture is dark with black horizontal bands somewhere in the middle of the screen. picture also rolls slowly in still mode. | ||
| SONY |
CCDF56
|
No picture / open trace | Unit had no pix in camera or playback, counter worked ok. video signal at tp004 was good, but missing on pin 1 of ic205. found open trace from resistor r061 to emitter of q238. _solution:repair broken trace. | ||
| SONY |
CCDF56
|
Pix rolling in viewfinder / replace c438 | Received unit with multiple problems, after replacing capskit most problems resolved. except pix is rolling in viewfinder. after troubleshooting, traced back to c438 which found a bad new capacitor. |