Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV27XBR50
|
Intermittent video&sound distorts, resoldered p/s regulator | Intermittent loss of video & sound distorts. | ||
| SONY |
KV27XBR26
|
No controls from remote or panel, replaced m board | No controls from either panel or remote traced to m board. | ||
| SONY |
KV27XBR10
|
Dead, high pitch sound heard, q503 shorted | Power supply oscillator at hi freq. nothing else works. | ||
| SONY |
KV27XBR10
|
No picture has hv, replaced d505 and r519 | No video hv present. | ||
| SONY |
KV27XBR10
|
Squeal from yoke, replace yoke 1-451-275-41 | Yoke sings causing high frequency whine when first turned on. | ||
| SONY |
KV27V55
|
Schematic error tp98 should be 12v not 15vdc | This service manual states the scan derived +b at tp98 (vertoutput) is 12vdc not 15vdc as indicated erroneously in the schematic.-hq comments: please let us know if the +/- 15v is reading 12 volts onthe other models listed in service bulletin 172r1. if | ||
| SONY |
KV27V55
|
Vertical jitter, replaced ic501 | After 10 minutes time of use, the screen jitters vertically. | ||
| SONY |
KV27V15
|
Popping in audio when switching channels, see sb 204 | Popping sound is heard from speakers during channel up/downor mute on/off activation. -hq comments: please refer to service bulletin number 204. | ||
| SONY |
KV27V10
|
Popping in audio when switching channels, see sb 204 | Popping sound is heard from speakers during channel up/downor mute on/off activation. -hq comments: please refer to service bulletin number 204. | ||
| SONY |
KV27TX29
|
Intermittent audio/mushy sound, replaced tuner | Sound is intermittent and mushy sounding. traced problem todefective tuner. | ||
| SONY |
KV27TW75
|
Intermittent picture, replaced tuner | Int. video and audio when wiggling rf input. | ||
| SONY |
KV27TW75
|
Dead & no standby 5v, replaced open r647 | Dead. no stby 5v. | ||
| SONY |
KV27TS35
|
Shut down, replaced q605, q606 | Either q605 or q606 was leaky. unit would shut down. i have seen this problem 4 times. | ||
| SONY |
KV27TS31
|
Dead, replaced r647 on "d" board | Unit dead, missing stanby 5 v. | ||
| SONY |
KV27TS29
|
Part #s for d board incorrect, reversed in sm | The service manual shows part # a1346112a in the 27 anda1346129a in the 32. the kcps computer shows the part number reversed.which is correct? -hq comments: kv-27ts29 a-1346-129-a kv-32ts36 a-1346-112-a | ||
| SONY |
KV27TS27
|
No blue, replaced ic301 | No blue in picture. pin 14 ic301 was 1.9v should be 4.4v. | ||
| SONY |
KV27TS22
|
Intermittent video and sound, resoldered if block | Loses video & sound. | ||
| SONY |
KV27TS20
|
Unit will go off station when cold, resoldered if block | Found apt transformer in if block had ring cracks. | ||
| SONY |
KV27S15
|
Main fuse opens, replaced c608 | The main fuse opens immediately. the problem was caused by ashorted capacitor/c608 in the doubler circuit. it is unusual to see thesecapacitors short in this fashion. i will forward the defective part. | ||
| SONY |
KV27S15
|
Cable box control problem., normal | The television and remote work fine. the problem relates tothe control of the cable box with rmy121. the range is too short whentrying to control the cable box with the remote. it is necessary to comewithin 1-2 feet of box. the cable box remote w |