Search: sony
Results: 20077
Make Model Symptom Problem Solution By
SONY MZR2
No operation from ac adapter (replace link ic on d-d conv) The unit would not operate from the ac adapter or the externalbattery case (which also plugs into the dc input jack).
SONY MZR2
Takes long time to record utoc after audio recording ends Unit takes a long time to record the utoc after audiorecording has finished (unit took about 11 seconds to record utoc).noticed that the rf pattern was fuzzy.
SONY MZR2
No record on right channel from microphone (line-in ok) The unit would not record audio on the right channel when using the microphone input. the left channel recorded properly. both channels recorded properly when recording from the line input.
SONY MZR2
Stops playing after a while (replace optical pickup assy.) Units stops playing after a while.
SONY MZE2
Unit does not play (replace open/close detect switch s806) The unit would not play when the play button was pressed.
SONY ICFCD800
Intermittent display - resolder all pins of ic401 Intermittent display.
SONY ICFCD800
Unit will not play several discs Unit will not play several discs. also when it plays it doesnot fully track the disc.
SONY D802K
Battery wire shorted or mis-connected Found positive battery wire shorted to the negative batteryterminal in the battery compartment. in another unit, found the positivebattery wire soldered to emitter of q453, rather than the collector as itis supposed to be connected.
SONY D34
Defective chassis assy. (x2625-248-1) received from npc New chassis assembly are being shipped defective, have foundoccasionally, spindle (m901) not placed on correctly. i recently wentthrough six chassis before finding a good one. i have samples here at thene hub.chassis are being brought up by steve nuniv
SONY CFD757
Sfdhhhh Servicer had a tc51 board that did not match the servicemanual. the only way we could fix the unit was replace the tc51. (techdept. did not have any information on the board either). the new boardworked only after all parts for the cfd767 were removed
SONY CFD510
No sound from left channel on tape only - change mag head No sound from left channel on tape only.
SONY CFD510
No power (new product) No power was caused by a crack in the power board. thefracture in the board transformer, which is board mounted, is supported bya metal bracket that is attached to the cabinet. the board, itself, isanchored by a washer and screw at its far end to the sa
SONY CFD440
Part numbers for optical pickup harness The service manual does not list the part number for theharness from the optical pickup. are these the same ones listed inservice bulletin #aud0174r1? the cfd440 is not itemized on that bulletin. -hq comments: yes. it does have the same harness. 1946
SONY CFD12
Part # correction: audio pcb (order p/n a-3264-272-a) On page 30 of the service manual, ref# 108 is part#a-3264-272-a (audio board, complete) but on page 34 the audio board,complete is listed as a-3264-373-a. which part number is correct? -hq comments: the correct number is a-3264-272-a.
SONY SLVR5UC
Correction to adj procedures Adjustment 1-4-13, rec chroma adj, specifies ic033 pin 6 asthe measurement point. this is incorrect.
SONY SLV757
No vhs hifi record in sp, but ok in ep. Unit recorded hifi in ep mode, but not in sp.
SONY SLV750HF
No vhs channels - intermittently Intermittently loses vhf.
SONY SLV750HF
Intermittent/no tuner Intermittent/no tuner. observed c652 had erupted.after replacing the cap would overheat and still had the same problem.measured 30v on the neg side of c652 coming from the junction of r811 andr812. -found: a carbon burn was found at h8 on p99(ma-144 b
SONY SLV750HF
List of error codes Unit will shut down in rewind. display shows l3802, i can'tfind a list of emergency codes in s/m. could you provide some? -hq comments:these codes should be the same as previous models. seeservice bulletin no. 181r1
SONY SLV750HF
No hi speed rewind Unit won't hi speed rewind, no remote operation, and pausecomes on when a prerecorded tape is inserted.