Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDSC5
|
Internal lithium battery - what is capacity? | Regarding the internal lithium battery (for date/time backup),what is the expected life of this battery, and what is it's capacity? -hq comments: this battery is expected to last for at least ten yearsunder normal usage (typically 10ua drain) before it | ||
| SONY |
MDP600
|
Part number for optical block incorrect/use 8-848-286-11 | Part number in service manual for the optical block(8-848-286-01) is not registered in kansas city parts. | ||
| SONY |
KV32XBR95S
|
Main picture showing through pip, cold solder on q3001/3005 | The main picture shows through the pip. you can see movement behind the pip picture. | ||
| SONY |
CCDF55
|
No camera/vtr ok/check cn601 - cn508 connection | No camera but vtr on. the dc to dc converter would not turn on. | ||
| SONY |
KPR53EXR15
|
Freeze mode is activated by vcr (slv595hf) remote rmtv1121 | Using the remote(rmtv112a) from slv696hf and activiting therewind function causes the kpr53exr15 to go to the freeze mode. -hq comments: we check a kpr46exr15 in pr along with the rmt-v112a andhad no trouble. we feel the problem is in the micro or rom. | ||
| SONY |
KV27TS36
|
Top and bottom of pixel strobe light and dark/on cable only | Customer has second set. still strobing on top and bottomof pix. only does it directly on cable, vcr plays ok. and, live airsignal ok. the cable company is prime located in chicago.has anyone heard of this problem? can anything be done for this cabl | ||
| SONY |
MDP605
|
Poor picture quality ic001/yc117 | Customers complaint was poor picture quality and sparklesafter about 10-15 minutes operation. replacing the ic corrected theproblem. -hq comments: ic001 is the y/c separator ic. | ||
| SONY |
CCDF50
|
No capstan motor rotation/check r058, q051. | No capstan motor function, tape stuck, no function from vcrportion of camcorder, eject indicator flashing. low voltage on pin 8 ofic007 (pwm,vs) was caused by an open connection between r058 and base ofq051. a wire bridge corrected the problem. -hq comm | ||
| SONY |
KV27XBR51
|
Stuck in video mode, replaced ic701 (a board) | Tv stuck in video mode. | ||
| SONY |
CCDV5000
|
Intermittent digital effects/check connection cn603 | Picture on ee and pb was ok, but digital effects did notwork. | ||
| SONY |
STRD911
|
Unit shuts down after 5 min. - improve ground connections | Unit shuts down after 5 minutes of use - brand new out of thebox. | ||
| SONY |
GV550
|
No video at rfu's output and audio is very noisy,ps401/402 | When using rfu connection, there is no video and audiois very noisy. | ||
| SONY |
MDP333
|
3" disc slips out of slot: replace cd sheet 3-735-039-03 | The 3 disc slips out of the table. these discs are beveledon the edge and when the drawer goes in and stops, the disc slips forwardslightly. when the unit tries to chuch, the disc is off center and aremarked. there were several different manufacturer | ||
| SONY |
STRGX99ES
|
Found additional ic on a class board - ic710 | Found additional ic mounted on a class board. power amp wasnot shown in the service manual and need schematic to repair. ic islocated next to cnp764. ic type is mitsubishi 5218a and package type is8-pin dip. -hq comments: 3/1/93 - we have fax'd tokyo | ||
| SONY |
STRD2090
|
Found additional ic on a class board - ic710 | Found additional ic mounted on a class board. power amp wasnot shown in the service manual and need schematic to repair. ic islocated next to cnp764. ic type is mitsubishi 5218a and package type is8-pin dip. -hq comments: 3/1/93 - we have fax'd tokyo | ||
| SONY |
ACV25S
|
No p/n for cn401 on cm36 board/use a-6768-302-a | The audio/video in connector part # isn't listed in theservice manual. you have to replace p/n a6768822a. the vmc assy, whichhas a $70.95 dealer cost and $87.95 list. most services try to make 40%minimum on parts so it costs the customer around $118. | ||
| SONY |
KV27V55
|
High pitch squeal, applied epoxy to fbt | High pitch squeal. | ||
| SONY |
CCDTR6
|
No eject, lm not running/replace q682, vs63 board | No eject drum spins, capstan spins but loading motor doesn'tturn. found no b+ on sensor com (+) line. | ||
| SONY |
STRAV570X
|
Poor reception on tuner - r703, q701 faulty | Unit turns on but no radio reception. i found shorted q701,and damaged r703. tuner board lost +13 b+, cannot tune, no radio. | ||
| SONY |
KV27XBR10
|
Loses vertical sweep intermittently, cold solder l513 | No vertical sweep intermittently. |