Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CDPC525
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
CDPC725
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
CDPC615
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
CDPC67ES
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
CDPC211
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
CDPC315
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
CDPC215
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
STRAV1070X
|
Hifi s/b no. 320 - invalid part number for r-975 | Service bulletin no. hfp0320 states replace open r-975 with1/2 watt 220Ω resistor part number 1-214-848-00. this part is nolonger available. | ||
| SONY |
SPP75
|
No handset transmit | Handset was not putting out any transmit signal. l-553 waspopped through the board and not allowing for oscillation. | ||
| SONY |
SPP75
|
Unit will not dial *, 0, or #, 7, 8, 9 in tone | Will not dial *, 0, or # in tone because the trace between pin6 of ic-351 and pin 20 of ic-201 is open (under ic-351). will not dial 7,8 or 9 in tone because the trace between pin 3 of ic-351 and pin 19 ofic-201 is open (under ic-351). open traces appe | ||
| SONY |
TAE1000ESD
|
Crack on analog board | Hair-line crack develops in area around mounting hole next tor902. this is a high-end product. i believe the (design group) needsextra effort with future products. this unit was purchased on january 11and it was received at the ssc on january 18th. | ||
| SONY |
STRD1090
|
Unit will cut off intermittently | Unit has intermittent audio when first turned on. +5v onoutput of pin 3 on ic-953 (5v reference) was too low (3.5v). | ||
| SONY |
TAM50
|
Part number correction: keyboard switches | The part number for keyboard switches: sw1 to sw8, and sw15 isincorrectly listed in the service manualas 1-554-937-11. | ||
| SONY |
CCDF35
|
No drum servo lock | No playback picture. drum speed constantly is changing.output of ic-501 pin 66 (drum d/a) is incorrect. too much data was beingoutput. | ||
| SONY |
CDPC221
|
Disc drawer does not close | Drawer would not close. disc table would rotate. | ||
| SONY |
KV27XBR50
|
No vertical lock when cold, replaced c-1345 (b board) | Picture would not lock vertically (roll) when cold. oncewarmed up, picture would have vertical jitter intermittently. | ||
| SONY |
KV27TW75
|
Inoperative set, replaced microprocessor ic-101 | No power on, no relay and standby 5v is ok. no data frommicro after jumping relay. | ||
| SONY |
FD280
|
Picture is blury, resoldered focus wire | Picture out of focus. reset rv-801 focus adjustment. focusimproved. however, after a few minutes focus went out again.opening the back cover i found the orange wire to g-3 on the crt notsoldered to the a board pcb. | ||
| SONY |
CCDV5000
|
Display flashes | Display is ok in stop mode. switch power to vtr mode anddisplay starts to flash (as if no lithium battery). no noticable currentdraw on external power supply. | ||
| SONY |
TAAX311
|
Noise on right channel | Noise on right channel. seems to be shock and temperature sensitive. |