Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDTR31
|
Need correct flex extension cable | The listed extension cable to connect cn-851 (vc-122) board tothe flex cable of the lens block is incorrect. the cable recommended(j-6082-138-a) has only 20 pins rather than the 21 pins needed. -hq comments: this extender should be used with the relay | ||
| SONY |
CCDTR31
|
Need correct extension cable | The listed extension cable to connect cn-801 (vc-122) board tocn-875 (cd-92) board on the lens block is incorrect. the connector has 16pins but is of a different design than previous models. see top of figure7-3 on page 168 of the service manual. -hq | ||
| SONY |
CCDV11
|
Caution light always on - intermittent video from cam | Caution light always is on and camera video is intermittent.the vtr functions are ok. records ok from camera when video available. | ||
| SONY |
KV32XBR35
|
No audio, connector a-12 not soldered | No audio line out or through internal speakers.troubleshooting with scope found audio entering ic-1010 but nothing on theoutput. checked dc voltages on ic. found 12 volt supply was missing.traced missing 12 volt to connector a-12 further inspections re | ||
| SONY |
TCM4040
|
Wrong belt part number | Belt ordered is the wrong belt. the belt needed is a fourinch belt. the belt received is a two inch belt. -hq comments: kcps checked their stock and found it to be correct. allthe belts in stock were 4 inches in diameter. this appears to have been ani | ||
| SONY |
XRU330
|
Part number for lcd holder not in the system (ref. 64) | Part number for the lcd holder (ref. 64) is not valid in thesystem. | ||
| SONY |
TAM30
|
Part number correction: keyboard switches | The part number for keyboard switches: sw1 to sw8, and sw15 isincorrectly listed in the service manualas 1-554-937-11. | ||
| SONY |
EVS700U
|
No power and no display clock | When unit is plugged into ac, you had no clock flashing and nosystem reset. | ||
| SONY |
D808K
|
Audio seems to echo at headphone out jack - fb-306 open | Audio sounds as if its in a tunnel or like an echo. checkedcoils to ferrite bead jumpers and found the ferrite bead jumper forheadphone ground was open. | ||
| SONY |
FD285
|
Speaker volume specification / 50mw | Customer claims the volume is too low. what is the volumeoutput specification ? hq comments: 50mw is the audio output specification.condition: 6.4v dc in jack 1khz 100% modulation 32Ω at speaker terminalthis model has been d | ||
| SONY |
STRD1090
|
Found additional ic on a class board - ic710 | Found additional ic mounted on a class board. power amp wasnot shown in the service manual and need schematic to repair. ic islocated next to cnp764. ic type is mitsubishi 5218a and package type is8-pin dip. -hq comments: 3/1/93 - we have fax'd tokyo | ||
| SONY |
EXCD40
|
Lamps stay illuminated when "acc" is switched off | Lamps and display stay illuminated when the vehicle's ignition is turned off. | ||
| SONY |
STRD2090
|
Cracked board around t-901 | Cracked mcb near t-901 transformer. this is low consumptionpart. i believe technicians are fixing board because board is still notbad enough to exchange. | ||
| SONY |
CDPC90ES
|
Magazine does not eject | As the magazine is being ejected, its lower left corner hitsthe lower left corner of the opening in the front panel. | ||
| SONY |
MDRWX50
|
Part nos. for headphones not shown in wm-wx50 manual | Unit received needing battery cover for wireless headphonemdr-wx50. these headphones are supplied with the wm-wx50. need partnumbers for battery cover, battery contacts and headphone left and rightdrivers for addressing out of warranty repairs. the $1 | ||
| SONY |
CCDF30
|
Distorted video - comes back in bmw when battery. voltage is low | Video was distorted. measured vcc at ic-362. found 6.5instead of 5. battery down did not work. turned power supply to 5.4 voltsand picture came back in black and white. also observed ic-360 wasgetting very hot. | ||
| SONY |
STRD790
|
Distorted audio on left channel | Distorted sound from left channel. traced signal to ic-701. | ||
| SONY |
KV20XBR
|
Sleep light is on, replaced d-657 and c-666 | No video and sleep light is on. traced voltages and found no5 volt. traced to 8v line to power supply and found d-657 was shorted. | ||
| SONY |
CDPC322M
|
Grinding noise while loading | Cd player would grind while trying to load. found s-701 bad. | ||
| SONY |
KV8AD20
|
No video in video mode, resoldered video jack | No video through rear video input jack. found a crack aroundsolder joint. |