Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDF34
|
Will not eject tape | Rm-95 indicates loading fault. manually released tray andfound that the back tension arm was causing the mechanism to jam. it wascaught on the wrong side of the guide pin in the left loading track. | ||
| SONY |
CCDTR6
|
No picture in camera mode | No camera picture, iris failing to open and all other func-ti ons are normal. confirm iris cannot be opened manually. disassemble iris and determine substantial lubricant on lower tip of iris blade. | ||
| SONY |
CCDTR5
|
Caution light comes on during rewind | Noisy erratic rewind because the tape became slack in the tapepath. the rm95 displayed 00.03 service mode error. no error was shownduring unthreading. determine multiple damaged teeth on arm assemblygear. installed no. 256, 264, 207 and 206. this re | ||
| SONY |
CCDF56
|
Not sharp view or focus | Chroma only, little or no luminance, playback normal. cameray appeared normal entering ic-401, but no output. determined ic-401 isdefective. | ||
| SONY |
CCDF401
|
No image in viewfinder | Camera picture is normal, distorted viewfinder raster on videoand found incorrect drive frequencies which indicated a defective ic-901. | ||
| SONY |
CCDF301
|
No picture in viewfinder | Viewfinder picture initially is normal. abruptly changed toexcessive brightness with complete loss of video. found apparent internalheater cathode short in crt. | ||
| SONY |
SLV353UC
|
Shuts down in play and won't accept tape | Unit would shut down, traced problem to defective cam gear. | ||
| SONY |
TCDD3
|
Tcd-d3 mechanical alignment | |||
| SONY |
TCDD3
|
Tcd-d3 mechanical alignment | Unit shows caution on the display. we have followed stepsnos. 1-6 according to s/b hfp0203 with negative results. when power isapplied to the unit, press power and cassette compartment ejects by itselfwithout pressing the eject button. when press down | ||
| SONY |
D303
|
How to connect lcd flex cable to keyswitch flex board | How can we connect the flex cable of the lcd to the keyswitchflex board? they appear to be bonded together by a means other thansoldering. we have a customer's unit which cannot be repaired because wedo not have any information on this type of connecti | ||
| SONY |
CPD1304
|
Intermittent failure of q-401 | I've heard reports that intermittent failures of q-401 can becaused by leaky diodes d403-871911013 and d404-871930186. | ||
| SONY |
SLV575UC
|
Test tape krv-51n part number | What is the part number of the krv51n vhs test tape referredto in fpr m1289? | ||
| SONY |
SPTC200
|
No video | No video output. traced problem to r-333 and one end hadvideo the other end did not. | ||
| SONY |
TADM1000ES
|
Unit goes into error | Unit would power up, receive switching signal and go intoerror. | ||
| SONY |
D66
|
No left channel audio on headphones | No left channel on headphones. third unit with this problem. | ||
| SONY |
D9
|
No play (no spindle drive, no focus search, no sled drive) | Unit's display came on but did not focus search. neitheric-502 nor ic-601 had power. found q-407 to be open. i have seen threeunits with this symptom. | ||
| SONY |
D11
|
No line out audio | No line out audio, right and left channels of hp jack seem tobe ok. | ||
| SONY |
D4
|
No power - intermittent | When play was selected, the display would light up for a sec-ond and fade fast. found that l-401 was open. | ||
| SONY |
KPR46EX25
|
Replay title locks on, ic-1202 also check d-202 | Unit will display large replay title in green at center ofscreen. is activated by ch index. when it happens, volume level bar andpicture level bar do not display at bottom of screen. replay cannot beeliminated and set must be unplugged or microprocess | ||
| SONY |
D180K
|
No play | Unit would not play discs. in the test mode no searchfunction occured. there was a reading of 1 volt (b+) on pin no. 38(ic-504). |