Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV32XBR10
|
How many channel caption available on this set, 32 | Customer clamins that they can not caption more then tenchannels on their set. please advise if the s/m is correct as to thenumber of captions avialable on this set. -hq comments: there are 32 captions available on this model as the s/mstates. | ||
| SONY |
FDL320
|
Replacement lcd assembly | Replacement lcd assembly has part of copper shield missing.missing shield exposes solder terminals. when shield plate (15 pg. 21)re-installed, it shorts exposed terminals. when terminals short, lcd isdamaged, or dc board is damaged. | ||
| SONY |
FDL320
|
Part number for battery lid | Customer needs a battery lid. part number is not anywhere inthe service manual. -hq comments: battery lid is part of the rear cabinet, they will not besold separately. | ||
| SONY |
KPR36XBR
|
Part number for cp-105, 1-235-084-11 | Cp-105 on (a) board has no part number. -hq comments: the part number is 1-235-084-11. | ||
| SONY |
KV2645RS
|
Vertical shrinkage, replace c518 | Set came in with vert. fold over, and vertical shrinkage.this unit had been worked on by an unauthorized person. i found ecgtransistors in the vertical output circuit. with the sony sub. trans q502(8-765-500-00) failed right away. replacing it with th | ||
| SONY |
PCM601ESD
|
No vco startup | Vco for sync separator ic would not start. if power wereremoved and immediately reapplied, vco would start. replaced q-529suspecting gain had changed - no difference. also applies to serialnumber 801237 | ||
| SONY |
RMX1
|
Short on acc b+ line | Replaced damaged remote cord and connected unit for testing.fuse on acc b+ line blew. dvm showed line was shorted, but when box wasopened and disassembled there was no short. reassembled and immediatelyblew another fuse. | ||
| SONY |
KV32SXR10
|
Brightness fluctuation, replace 12v reg ic-105 | Brightness on picture tube would vary at a rapid rate, butvery slight. scope shot of rgb signal to crt at a-16 connector revealedslight dc shift which was in phase with brightness changes. further testsrevealed the following. the 12v line measured 11v | ||
| SONY |
CPD1302
|
Bad purity | Two problems noted - thermistor shorts - blows fuse.thermistor overheats - melts solder where mounted to board causing openconnection. | ||
| SONY |
CPD9000
|
Curvature of crt | We need the specification on the curvature (radius) of thecrt used in this model. -hq comments: _______ | |y= 11560mm |_______| x= 2275mm | ||
| SONY |
SL2500
|
Shutdown in ff or rew modes only | Shuts down in ff or rew. all other operations, play, recordand swing search are normal. | ||
| SONY |
CDXR88
|
Audio cuts out intermittently | Audio will cut out - sometimes with time or with temp. | ||
| SONY |
CCDV11
|
Base (1) guide rail assembly missing a guide pin | Picture rolling, looses vertical because tape tension is notnormal without the post that is shown on the picture attached. founddifferent base (1) with and without the guide - needs assistance, to findpart number for guide missing, not shown on any serv | ||
| SONY |
CCDF45
|
Incorrect part number d-301 | Correct part number 8-719-820-44. -hq comments: thank you for the information. a service bulletin willbe issued. see csv-3 no. 162. | ||
| SONY |
SPP80
|
Constant buzz in audio | There is a constant buzz onto the speaker of the handsetas soon as the talk button is pressed and the receiver is energized. | ||
| SONY |
KV27XBR10
|
Severe pincushion distortion,replaced l-501, r-571, and q505 | No correction occurring, l-501 and r-571 open q-505 shorted.this is the forth set i have seen with these parts bad. ic-531 also re-placed. labels for q-505 pins are incorrect on the board and in s/m boardlayout it would be difficult to install the tran | ||
| SONY |
KPR41DS2
|
Vertical convergence problem, replaced the neck ass'y | Vertical convergence problem. eight out of eleven units hadthe same problem. serial numbers which also apply are: 8015025, 8014453,8014500, 8015063, 8015069, 8014430, and 8014424. | ||
| SONY |
CCDF330
|
Dark picture - no luminance intermittently | Multiple intermittent problems with camera video whencompletely assembled. clears up when camera pc boards are removed fromtheir mounting positions. | ||
| SONY |
KV27XBR10
|
No character display, cold solder c-517 ("a" board) | Servicer had changed ic-101 and ic-301. with set on and audiomuted, found no clock activity at ic-101/pins 34 and 35, so no displayoutput at ic-101/62. found no h-ref pulse at ic-101/59. power supply of thispulse is c-516, c-517, c-518 divider off q-503 h-o | ||
| SONY |
SL340
|
Flex connector not supplied between the mf-40 & vs-33 bd's | On page 62 of the sl-340 service manual it says that thiscable is unavailable. is this correct? can we get a part number for thiscable, i have a servicer who needs one? -hq comments: the flexible cable part number is 1-563-626-11. |