Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDTR5
|
Poor video in playback | Drop out in rf playback envelope (one of four missing).appears to be tape path or head problem. | ||
| SONY |
STRAV910
|
Microprocessor reset | When switching the surround from any mode to simulated (i.e.dolby to simulated, live to simulated etc.), the main and surroundspeakers mute. when switched off or back to any other mode, only thesurround speakers come back on. by switching the input sele | ||
| SONY |
CCDV5000
|
Part number for extender cable | I need a part number for an extender cable to go fromthe fd-13 board (cn212) to the ss-95 board (w226). it should be a26p conductor. the part number does not appear to be in the servicemanual. -hq comments: the part number is j-6082-055-a, 26 pin 1mm | ||
| SONY |
CDPC500
|
Counter not reading correctly | While playing a disc, the counter would not count correctly.for example, the display would jump from 1:00 to 1:42 and then pause.meanwhile, the audio would play normally. when the disc got to that timespot, the display would jump again. ams function al | ||
| SONY |
TCWR710
|
Different audio system control board - s/m does not match | The part number on the replacement board is 1-630-624-12a.the part number on the board in these units is 1-630-624-13a. cn-802 isa 19 pin plug on these units and 18 pin in service manual and replacementboard. this also pertains to serial number 816936. | ||
| SONY |
KPR41DS2
|
Front bezel, not available | Is front bezel available? servicer damaged bezel whenchanging l & f diffusion plates. is entire cabinet available? | ||
| SONY |
SLV70HF
|
Unit locks up no operation | Press play unit locks up - fast fwd, rewind and playinoperable. | ||
| SONY |
GV8
|
No eject | Unit would not eject.motors would not run. found f-101 andf-104 open on (ps-181) board. replaced fuses and unit would still noteject. loading and capstan motors would run in an attempt to eject, butcassette compartment would not release. i found that | ||
| SONY |
CPD1302
|
Picture blanks in digital mode | Monitor works fine when the analog/digital switch located onthe rear panel of the unit is set to analog. but, when the switch is setto digital the screen will blank. | ||
| SONY |
CPD9000
|
Dead unit | Unit was received in non-operating condition. furtherinvestigation led to finding a cracked (da) board. (da) board was re-placed with no luck. | ||
| SONY |
KV5100
|
Replacement for ac cord does not fit | Power cord replacment 1-551-298-00 does not fit. originalpart number was 1-551-181-00. -hq comments: check with tokyo and kcp. they have been using this cordfor the past four years with no trouble. please order this part again. | ||
| SONY |
RMP201
|
There is no service manual for this remote | There is no service manual on this unit. is it servicable? -hq comments: this is a non-repairable remote control. the entireremote control can be ordered through kc parts. the p/n for the rmp-201is 1-465-143-11. | ||
| SONY |
FDL330S
|
Part number missing | Need part number for the part which screw no. 69 goes through.page 28 in service manual on battery board. -hq comments: part number is 1-565-861-11, reference number cn-601. | ||
| SONY |
SL300
|
Eats tape | Unit would thread as soon as power plugged in. then would not eject, but was trying to eject. if unloaded manually, then unit would load tape normally but again would not eject. | ||
| SONY |
CCDV99
|
Poor audio record with loud pops | Records audio poorly with loud pops during camera recordings | ||
| SONY |
SPP100
|
Replacement of ringer speaker on handset | To obtain the ringer speaker (sp-201), it is necessary toorder the front cabinet because the speaker is not available separately. | ||
| SONY |
KPR36XBR
|
Dead unit with sleep light on, cold solder on l5008 | Unit appears dead. there is no video or audio but the sleeplight is on. both the +12 volt and the +15 volt lines were down. | ||
| SONY |
CPD1304
|
Vertical picture bouncing | Vertical picture bouncing (2-3 times/second). finally, theraster may settle in a certain position. | ||
| SONY |
CPD1302
|
Vertical bouncing | Picture is unstable in all modes of operation. also, the80 volt line measures high. | ||
| SONY |
EVS900
|
No playback of pcm recordings | Unit will record pcm audio but will not play it back. lppcm played back garbled. video playback was ok. |