☰

Sony Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY CCDV5
Part number error, lens block repair guide The correct part number for the af section assembly shown onpage 3, of the lens block repair guide (vcl-1206yh,yk) is 3-707-539-01. -hq comments: the correct part number is 3-707-539-01. see servicebulletin cam0097.
SONY SPP150
No code sent to handset from base Power light on base continues to flash when handset placed onbase. handset is ok. determined that code comes out of ic-501 pins 45 &46 then transmitted from base to handset over the air - not through topcharge terminals. when handset placed on base, c
SONY KV32XBR15
Vertical retrace lines, re-soldered c-504 ("a" board) I have now seen several models, anu-1 chassis that exhibitwhat looks to be an odd type of retrace at the bottom of the screen.there may also be a few lines missing in the middle of the screen. it isunlike vertical problems i have seen in the past. the
SONY SL2000
Cassette will not stay loaded-cannot close cass. compartment Reference item number 372 on page 4-8 of sl-2000 servicemanual becomes intermittent in operation and adjustment of position doesnot solve the problem.
SONY GV8
Part (window sc) not included with cabinet (sc) assembly Customer ordered new cabinet part (ref. no. 51) for gv-8. notincluded was the screen, although the manual shows the screen should beincluded in the assembly. -hq comments: part number for screen is 3-728-933-13.
SONY KV27TX20
High-pitch noise, replace l-510 (hlc) High pitch noise coming from unit.
SONY TCFX110
Part number for t-reel assembly The part number for the take up reel assembly is not listed inthe service manual. -hq comments: please refer to the tc-fx150 service manual since thesedecks are similar. the part number is 4-894-963-01.
SONY DRP1
Repair/exchange status No schematic is provided for this unit only a one-pageservice manual exists. do we repair or exchange it? -hq comments: please exchange the unit. this model will be added to theexchange list.
SONY CCDV11
Quick repair of ccd-v11 lens unit assembly Broken focus ring - zoom ok.
SONY KV2092AEB
Rear cover p/n, 4-376-474-11 Part number needed for rear cover. -hq comments: the part number is: 4-376-474-11.
SONY CCDTR5
Door will not close The tp arm block assembly (page 215, reference number 175) hadcome out of unit. the t protector assembly was bent. replaced theseparts (including washers and joint bar). unit would close and start toload. then unit would jam due to misalignment of tp
SONY ICF2010
Incorrect scan After entering the lower and upper scan limit frequencies in,the unit would not scan correctly after pressing the scan start button.this also pertains to serial numbers 302902, 302903 and 303001.
SONY STRGX6ESII
Insulating mica part number I need the part number for the insulating mica for the outputtransistors (2sc2921/2sa1215). not listed in two page service manual forthis model and different than those used in gx6es. because of the largesurface area and suction of heat-sink compound,
SONY D160
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY D180
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY D9
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY D4
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY D2
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY CDXR79
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY CFS902
Part number listed for s302 is wrong Part number 1-570-347-31 is a two-position switch. this is the wrong switch. it needs to be a three-position switch.