Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY KV27SXR10
High pitch sounds, replaced yoke see sb #0114 High pitch squeal.
SONY CDXR77
Replacement optical blocks Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. this is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. this also is true on other models.
SONY SLV70HF
No playback of self-recorded tapes When playing back a self-recorded tape, a picture can only beseen in the scan modes. pre-recorded tapes playback ok.
SONY STRGX5ESII
Unit resets when volume down pressed on remote When the volume down button is pressed on the remote, the unitgoes into reset and comes back on. all else is ok.
SONY EDV9500
C/r picture shifted to the left In the cue or review mode the picture is shifted horizontallyabout 1/2 inch to the left.
SONY SLV70HF
Record level volume control has no effect The record level volume control has no effect on audio recordlevel. the sound is recorded very loud.
SONY KV27TS30
No picture, shorted picture tube G-2 shorted.
SONY CCDTR5
Low luminance on playback Unit had low luminance level when playing tapes recorded withthis machine prerecorded tapes played fine. pin 24 of ic503 had luminancelevel of about 1 volt. pin 25 level was 0.6 volts.
SONY SLHFR70
No pb picture (no drum rotation) Drum motor will not rotate.
SONY CCDF70
Does not eject Does not eject cassette or does not open when empty.
SONY KV27AVR
Additional circuit board Servicer had unit that would function properly if unplugged &plugged in again. however, if unit was turned off with power switch, thenback on with power switch no functions would operate. servicer found anextra circuit board assy. in the unit (not in s
SONY SLHF870D
No audio No audio on playback or it takes about a minute before audiocomes on playback. normal sound during tuner reception.
SONY CDPC401
Part number for remote rm-d505 The cdp-c400 and c401 is supplied without a remote control.since this unit has a remote control receiver on the front panel, whichcommander should be sold to the customer if they want one? -hq comments: please sell the customer the remote commander rm-
SONY CDPC400
Part number for remote rm-d505 The cdp-c400 and c401 is supplied without a remote control.since this unit has a remote control receiver on the front panel, whichcommander should be sold to the customer if they want one? -hq comments: please sell the customer the remote commander rm-
SONY CCDF35
Intermittent shutdown Unit comes in with intermittent shutdown.
SONY CDXR79
Service bulletin eratta csa-14 #157 Car stereo csa-14 #157 contains two errors. line 2 of thesolution states (pin 4 of ic309), this should read (pin 4 of ic390). thecircuit diagram shows the added cap with the positive lead connected toground. this is backwards. with the cap installed
SONY CDXR77
Service bulletin eratta csa-14 #157 Car stereo csa-14 #157 contains two errors. line 2 of thesolution states (pin 4 of ic309), this should read (pin 4 of ic390). thecircuit diagram shows the added cap with the positive lead connected toground. this is backwards. with the cap installed
SONY CCDTR5
Intermittent caution light Found that unit loaded, recorded but on playback (after zeromemory of about 10 minutes) picture was all snow except a dark 1 inch lineat top. after further inspection found that guides would not load arounddrum causing tape to ride up pinch roller. uni
SONY KV27XBR10
No picture, replaced crt, pins 5 & 6 inside crt shorted No raster. set had no video present at pins 20, 22, 24 ofic-301. i suggested that the voltage on the crt socket should be checked.pin 5 of crt had only 115 vdc on it. further checks revealed that pin 5& 6 in crt were shorted together. the servicer ha
SONY KPR46CX10
Clock runs fast, see s/b tvp088 Clock runs fast. -hq comments: please refer to service bulletin number 88.