Sony Repair Tips
Search: sony
Results: 20072
Results: 20072
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
FE-1
|
Excessive width | This was due to q532 2sk2251-01 being s/c, it is advisable to also check other ew circuit components as a precaution | ||
| SONY |
KVM1400
|
Will not power up, red led blinks twice | Replace icp fuse in ht line ps801 n15, 600ma mounted adjacent to pin 7 of lopt | ||
| SONY |
KV2165MT
|
Main fuse blasted | Replace the str50115 | ||
| SONY |
FE-1
|
Band of interference down left of screen on dark scenes | This was cured by adding a 1000pf, 2kv capacitor part no. 1-161-731-81 in parallel with d539 in the ew diode modulator circuit | ||
| SONY |
FE-1
|
Loss of one colour with teletext and on-screen displays | Check the appropriate 2sc2412k transistor q007 green, q008 blue or q009 red | ||
| SONY |
KV28WS2U
|
No sound, speakers pop out if volume is raised from zero. audio output from dolby a1 board at +5v dc. | Lightning damage to this set and connected vcr. centre/surround amplifier ic shorted blowing ic protector to its negative rail. both amplifier ics replaced as a precaution. no damage to dolby a1 board | ||
| SONY |
KV-25M80 BG-2
|
Dead | 5v supply transformer short | ||
| SONY |
KVS3432U AE2
|
Front led flashing 13 times, ht at first came on at 139v then went to 75v going off etc shuting back down in protection mode | Found r854 open circuit on -15 volt line off line output transformer | ||
| SONY |
KV2184
|
Main fuse blasted | Replace the str50115, also replace the mains electrolytic capacitor | ||
| SONY |
FE-1
|
No teltext just p100 | This problem was caused by q405 2sc2412k being s/c | ||
| SONY |
FE-1
|
No power although relay operates main p.s.u inoperative | Check ic606 strf6654 for failure, also check resistors r659 0.33Ω,3w, r660 0.39Ω,3w, fusible resistor r603 0.1Ω,0.5w and capacitor c625 100uf,25v | ||
| SONY |
KX27PSI
|
Almost totally dead. no video or audio whatsoever. only the clicking sound of two power relays when the set is turned on, and conversely at power down. the green/red lights on the front panel do appear. repeated failure every 2-3 years. why ? | An insight into what tv engineers did, after speaking to sony uk: a 0.47k resistor replaces l656 in line to q651 b. b 0.33Ω resistor added between l650 and q651 e. a resistor also replaces l657. still lasted only 2 years. any better ideas ? | ||
| SONY |
KVA2942U
|
Led a flashes once, led b flashes 13 times. | Bad solder joints on field ic1501 on back edge of main pcb | ||
| SONY |
FE-1
|
After about 30 minutes the set goes to standby, the led flashes and tv starts again. after 1 minute the tv displays : antenna connection failed! | Change ic101 of if on a-board. order nr. 875946647 | ||
| SONY |
KV-X2183E BE3B
|
Not working, stand-by indicator led flashing 6 times, power supply ok | The tuner has loose connections, especially the ground points and the two smd ic´s | ||
| SONY |
KV27EXR25
|
No power, no raster, relay comes on | Found horizontal trans short | ||
| SONY |
AE2
|
Sound low & distorted when hot | Check -22v & +22v on plug pl505, if either incorrect check r627 27~ goes high in value | ||
| SONY |
KV28WS2U
|
Osd volume bar present continuously. no functions available | Front panel tactile switches leaky. replace same | ||
| SONY |
KV2032
|
Keeps changing channel | Check voltage on d12 if below 4.8v then change | ||
| SONY |
KV-20VM20 SCC-H16B-A
|
Would not eject the tape | Replace elevator activator rack broken ref# a34 oem# 9-908-164-01. - ul# 146t - set mfg. by goldstar similar to: zenith tvr1920 & kv-13vm20 |