Thomson Repair Tips
Search: thomson
Results: 227
Results: 227
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
THOMSON |
TX805
|
St/by only | Rp92 o/c (0.68Ω in 14" ) ( 0.56Ω in 20" ) | ||
THOMSON |
TX80
|
Dead with mains fuse o/c | Tp 10 (s2000a or bu508a), cp08 (100uf/63v) | ||
THOMSON |
RP46
|
Tripping - eht splitter faulty, new one has short life | R18 220k hi res & check r9 100k 2w | ||
THOMSON |
IKC2
|
No col via scart - ok off air | 4.43mhz xtal | ||
THOMSON |
IKC1
|
Int start up unless vots i/p is 160vac | Cl65 smoother on the 13v rail (measured ok) | ||
THOMSON |
ICC9 37MG73J
|
Pic break up with folded horiz lines at bottom half | Rf11 safety res 1r5 o/c pt no 15022560 | ||
THOMSON |
ICC9 37M973J
|
Service mode entering | Switch on holding in blue txt button then press blue button again | ||
THOMSON |
ICC9 37M973J
|
E-w bowing | Iv01 stv2160 replaced & uprate cv46 from 10nf to 22nf sm; rl45 3r3 o/c, ll08 pt no 10092690, cl42 4µ7 160v | ||
THOMSON |
ICC9
|
Trips on & off aft 1 min | Ok when you s/c tr96 sm st/by tr - tv92 sm was the cause even tho it check ok out of cct | ||
THOMSON |
ICC7
|
Field tda 8172 | Note from sm page 3 : if pin 8 på ic 7600 is at 0 volt, then there is a fault in the prot circuit. | ||
THOMSON |
ICC19 28DG35UD
|
Dead with led flashing | Unplugging dolby module restored pic. tda2615 amp chip is450 blasted - pt no 10257880 | ||
THOMSON |
ICC19 28DG35UB
|
Tuning mode | From st/by hold down menu button & the set will turn on in preset mode. follow on screen prompts | ||
THOMSON |
ICC19 28DG35UB
|
Pin code unsetting - "type in 4 digit code" message | Hold down both prog & vol minus(-) button on tv & switch on. release buttons & you should be in service mode.navigate with arrow buttons on remote to "setup" then select "erase pin" by holding down the right arrow button for 5 secs until yellow tick appears in box.you must backtrack to find the "quit" option to exit & store the new info. | ||
THOMSON |
ICC19 28DG35UB
|
Int shows pic but usually error code indicating faulty txt | Replace txt panel | ||
THOMSON |
ICC17 32WS23U
|
Trips 3 times then dead | Loptr & loptx faulty | ||
THOMSON |
ICC17 32WS22U
|
Dead - at sw on led turns green then flashes amber twice, goes green then flashes amber 6 times & repeats | Dry joints crt base | ||
THOMSON |
ICC17 28WS23U
|
Tuning procedure | Sw off tv mains whilst in st/by. hold chan - on tv whilst sw on. full auto tune menu appears | ||
THOMSON |
ICC17 28WS23U
|
Shuts down at sw on aft eht rustles up | Loptx replaced stopped shutting down but still no sound/vis - cb01 10nf 3kv in a1 supply on crt base leaky | ||
THOMSON |
ICC17 28WS23U
|
Dead apart from red led that does not change | Loptx low res turns all ways round | ||
THOMSON |
ICC17 28WR25UG
|
Dead - no st/by light | Dp21 37v zener bzx85c39 also check rp20 470r. |