Thomson Repair Tips
Search: thomson
Results: 227
Results: 227
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| THOMSON |
ICC9
|
Trips on & off aft 1 min | Ok when you s/c tr96 sm st/by tr - tv92 sm was the cause even tho it check ok out of cct | ||
| THOMSON |
ICC7
|
Field tda 8172 | Note from sm page 3 : if pin 8 på ic 7600 is at 0 volt, then tsound is a fault in the prot circuit. | ||
| THOMSON |
ICC19 28DG35UD
|
Dead with led flashing | Unplugging dolby module restored pic. tda2615 amp chip is450 blasted - pt no 10257880 | ||
| THOMSON |
ICC19 28DG35UB
|
Tuning mode | From st/by hold down menu button & the set will turn on in preset mode. follow on screen prompts | ||
| THOMSON |
ICC19 28DG35UB
|
Pin code unsetting - "type in 4 digit code" message | Hold down both prog & vol minus(-) button on tv & switch on. release buttons & you should be in service mode.navigate with arrow buttons on remote to "setup" then select "erase pin" by holding down the right arrow button for 5 secs until yellow tick appears in box.you must backtrack to find the "quit" option to exit & store the new info. | ||
| THOMSON |
ICC19 28DG35UB
|
Int shows pic but usually error code indicating faulty txt | Replace txt panel | ||
| THOMSON |
ICC17 32WS23U
|
Trips 3 times then dead | Loptr & loptx faulty | ||
| THOMSON |
ICC17 32WS22U
|
Dead - at sw on led turns green then flashes amber twice, goes green then flashes amber 6 times & repeats | Dry joints crt base | ||
| THOMSON |
ICC17 28WS23U
|
Tuning procedure | Sw off tv mains whilst in st/by. hold chan - on tv whilst sw on. full auto tune menu appears | ||
| THOMSON |
ICC17 28WS23U
|
Shuts down at sw on aft eht rustles up | Loptx replaced stopped shutting down but still no sound/vis - cb01 10nf 3kv in a1 supply on crt base leaky | ||
| THOMSON |
ICC17 28WS23U
|
Dead apart from red led that does not change | Loptx low res turns all ways round | ||
| THOMSON |
ICC17 28WR25UG
|
Dead - no st/by light | Dp21 37v zener bzx85c39 also check rp20 470r. | ||
| THOMSON |
ICC17 28WF25U
|
Int reverts to st/by with red led flashing | May run again for a while when sw back on - leakage in focus spark gap. fit new crt base pt no 80298800 | ||
| THOMSON |
ICC17 28WF25U
|
Dead with all volts appearing at psu o/p at 1/2 normal value briefly at sw on | The 39v i/p to tp21 chopper tr in st/by psu low at 11 v - dp21 39v zener leaky | ||
| THOMSON |
ICC17 28VK24 ETC
|
Dead with red led blinking 2 then 7 pulses | Loptx - comes with mod kit 35175720. also check fop chip if01 & cct prot zl11 for damage by loptx | ||
| THOMSON |
ICC17 24WK24U
|
Tripping with red led in sympathy | To disable trip s/c tl17 e-c; blank raster with fb lines now present; field fback supply missing due to zl11 mp25 o/c | ||
| THOMSON |
ICC17 21DK24U
|
St/by led flashes - comes on using r/c but excess brill with fback lines | 196v ht to ib01 tda6107q rgb o/p chip missing on crt base - rb06 220r o/c | ||
| THOMSON |
ICC17
|
No sound or vision - low humming | Ts81 bc847b sm leaky c-e | ||
| THOMSON |
ICC17
|
Led gives 3 orange flashes | Loptx | ||
| THOMSON |
ICC17
|
Excess width & e-w faulty | Tl41 bd241c dry jointed, dl22 byw76 s/c |