Thomson Repair Tips
Search: thomson
Results: 227
Results: 227
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| THOMSON |
VARIOS
ICC17 |
Led lit red inactive power supply | Transistor tl 59 shorted | Replace with the same | TECNICA ORIMA |
| THOMSON |
VARIOS
ICC17 |
Low contrast image | Transistor tl02 shorted by tsl discharges | Substituir tl02 tsl | TECNICA ORIMA |
| THOMSON |
VARIOS
ICC17 |
In the mp ir02-3.50g version, after being on standby for 5 minutes, it stops receiving orders from the tlc and the front panel | Add a resistance 39r 0.25w between pin 8 of ic ir03 and rr16 | TECNICA ORIMA | |
| THOMSON |
VARIOS
ITC008 |
The/image only with/grain | 5v is missing on pins 6-7 of the tuner- | Substituir dp036-1n4001 | TECNICA ORIMAS |
| THOMSON |
VARIOS
ITC008 |
With dark mat-screen | Diodes dl004 and dl015 shorted - replace | TECNICA ORIMA | |
| THOMSON |
VARIOS
ITC008 |
If001 vertical ic heats up a lot | Rf008 1.5r exhausted - replace | TECNICA ORIMA | |
| THOMSON |
VARIOS
ETC210 |
Power supply does not start when cold, heating power supply area starts | Photo acupller ip030 and ip070 with deficiency | Replace ip030 and ip070 | TECNICA ORIMA |
| THOMSON |
ICC20
ICC20 |
It takes a long time to start up and yet it gives code 2 6 which means "tube does not heat up in time" | The memory no longer sets the correct time, change ll200, "remove 5 turns from the coil" | "remove 5 turns from the coil" (ll200) | |
| THOMSON |
29DF42E - S
ICC20 |
It takes a long time to start up and yet it gives code 2 6 which means "tube does not heat up in time" | The memory no longer sets the correct time, change ll200, "remove 5 turns from the coil" | "remove 5 turns from the coil" (ll200) | |
| THOMSON |
RCT3003 CHASSIS TX91
|
Image with grain via tuner, via scart perfect image | Replace c.electr.perto do tuner and solve or tuner not inside | ||
| THOMSON |
TX91
|
Vertical position. moved 10 cm upwards | Tl 13_ bc338 line of 13 v. defective | ||
| THOMSON |
20MG130G CHASSIS TX807C.
|
Does not turn on. 8v and 3.2v are missing on pin 1 of the tda9554ps. | Defective tda9554ps brings down the ic ip090 (stv8130). | ||
| THOMSON |
20MG130G CHASSIS TX807C
|
Normal sound with green screen and return lines, (underneath, the image was noticeable but, it was very dim, it was not possible to perceive it). | Replace dl015 + dl014(1n4148) + rl015 (100r). | ||
| THOMSON |
20MG130G CHASSIS TX807C
|
Doesn't start | Broken track between tl031 collector and tl032 base | ||
| THOMSON |
TX-807 C EU
|
With sound without video, dark screen increasing ug2 presents trc support type colors with humidity (no image definition). | Vertical i.c if001 tda9302h and rf1r5 open | ||
| THOMSON |
32WF45E CHASSI ICC20
|
Turns off after 5 minutes of operation image on ost/west with small wavering leed blinks 2 times and then 5 infinitely does not work again turning on again, only much later. | Change the 2;2mf cl036 on the ost-west circuit | ||
| THOMSON |
CHASSIS TX91G
|
Doesn't work - front led flashes red | Replace memory 24c04 | ||
| THOMSON SABA |
TX807VST = 418
|
Dl21 = bav21 | |||
| THOMSON |
CHASSI TX807CS
|
Dead: LED doesn't light up, fuse and shopper transistor don't burn out | See transistors tp022 and tp032 | ||
| THOMSON |
ICC7 & ICC8
|
Vertical - tda8178fs shorted, no longer manufactured | Subs. by stv9379f, solder res 3k9 between pins 2 and 7, solder zen. bzx75c2v1 anode pin 7 cathode ground |