Toshiba Repair Tips

Search: toshiba
Results: 5592

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	TV2996S	Takes time to depart the stand bay	Capacitor 47/50 do stand bay	Replaced the 47/50 stand bay capacitor solved the problem	serv maq eletronics
SEMP TOSHIBA	TV2090-IAVU14	Horizontal exit burn	Q406=c1815 / q403=x112
TOSHIBA	TV2079FMS U11	Blue screen, no characters and perfect sound.	Pin-20 of the one chip that should send 2.5 volts to the rgb board, where it itself is what powers the base of the transistor r of the rgb board.		Diângelis D`el
SEMP TOSHIBA	2092MAV U17	Does not turn on or the LED lights up	Q 801 str shorted d883 shorted		flavio
TOSHIBA	1470 1470	Generating a lot of squeaking noise from the flyback pacifier	Tube(kinescope0exhausted	Replace the same	ANTONIO NOBREGA [PATOS.PB]
TOSHIBA	TV -2999 JMS LEM6	Does not amplify the audio signal at the output ics as if the mute was activated but generates very low audio at maximum volume	Transistor q907 dtc124 on the kinescope board with leakage	Replace transistor q907	oltecti
TOSHIBA	2998EMS LEM5	Screen with rich black appearing shutter effect but black	Replacing capacitors c213 and c214		MACC ELETRONICA
SEMP TOSHIBA	20A77 U8	Power supply with approximate voltage of 51 volts and does not oscillate	Electrolytic capacitor c877 exhausted		MACCELETRONICA
TOSHIBA	U15	Dark image	The writing does not work and the characters are blurred;	Capacitor located in the tube socket, c902, 102k or 1.02nf	This email address is being protected from spambots. You need JavaScript enabled to view it.
SEMP TOSHIBA	TV 2092 LAV U16	Vertical open only 3 centimeters	Shorted transistor q430	Replace with bd135	fabiusmax
SEMP TOSHIBA	TV 2092 LAV U16	It didn't work, be careful with changing the transistor q430	It didn't work, it didn't come out of standby, I replaced the Q430, it wasn't original, I thought an RGB driver transistor, tube board would solve the problem.	The vertical kept closing at the bottom after a lot of brainstorming I thought about replacing the q430 with a bd 135 and that's it, here's just a tip so we don't waste too much time on simple things hugs	fabiusmax
SEMP TOSHIBA	TV 2092 LAV U16	It didn't work, be careful with changing the transistor q430	As I said, it didn't work, don't leave standebye		fabiusmax
TOSHIBA	U14	The TV even turned on but for a second then it turned off. And it didn't turn on again. So I turned off the +b on the flayback to check the power supply voltages and then everything was ok. Then I turned it on and it oscillated normally, but when I turned on the +b again it returned with the problem	SOLUTION I replaced the flyback and the solution was that it was shorted. Then also check the transistor x112 and c1815 which are close to the flayback, in mine they were faulty		This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV2051NAV U18	Chido na power supply imajem instavel	Q862 photo coupler	Replace	ze nunes
TOSHIBA	50PJ98G PB8773	When we turn it on, the red LED lights up, turns green and turns red again and the protection relay arms.	R-g-b board ci stk392-110 faulty	To optimize the breakdown on this TV, just turn off the modules one at a time and see when the relay no longer activates, this way it will be easier to start.	This email address is being protected from spambots. You need JavaScript enabled to view it..p
TOSHIBA	2083AAV U9	You tune it to a single channel and when you change it, it goes to AV, that is, it doesn't change in sequence, only if you type the channel number on the control.	Memory with data is buried.	Replace the memory.	This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV2958 FS6	Screen washed, with traces of return, without OSD, turns off after a few seconds and turns on again.	Measuring with the oscilloscope, data line, scl/sda. I observed that at the moment the device turned on, it was present, then disappeared.	Changing the memory, 24lo4af solved the problem, note. if you don't have it, the 24c04 will do	Loimar Silveira Sta.Tereza Rio de Janeiro
TOSHIBA	TV2157FS U18	Like fanhoso	Change in spot trans	Replace trans do spot q906	Ricardo JRC
DVD TOSHIBA	SD5091VK	Does not open the tray when you press open close, it also does not appear indicating on the display	Broken trail on pins 3 and 4 of c.i u2 of the display	Make the amendment and that's it.	wagner
TOSHIBA	TV1483	Volume acts alone	Key sa03		ANTONIO NOBREGA [PATOS.PB]