Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 2004
|
The TV turns on the LED, you try to turn it on, the LED turns off but the TV doesn't turn on. | Q803=bc337 with the base and collector open. | It was replaced and resolved. | Armando da Eletronica EvoluSom,Olimpia. |
| CCE |
HPS 2997FS
|
Burning abl line resistors | Shorted flyback | paulorusso | |
| CCE |
HPS-2185FS HPS-2171FS
|
Power supply inoperative nor the standby LED lights up after a while it turns on normally @@@ | Ic 801 (tea1533at) da power supply | ELETRONICA ARNI-L. LEAL- SC | |
| CCE |
HPS-2071 E 1471
|
Normal power supply has all voltages 103v and 16v @@@ | Cristal do micro x701 | ELETRONICA ARNI-L. LEAL- SC | |
| CCE |
HPS1471
|
It turns on immediately after the image appears, a black band appears horizontally and interferes with the blue screen and intermittently turns off normal power supplys | C-417 with fault measuring it is good to change without measuring. | Capacitor replaced. | play back |
| CCE |
TV 2918 USP
|
Image shaking and closing on the sides | C 402 | Wanderlei | |
| CCE |
HPS2981C
|
5v power supply does not work with 3v | C825 as low capacitance | PEDRO EUGÊNIO | |
| CCE |
HPS2991 FS
|
It has audio, loud, filament and no brightness | Q409 | I replaced the capacitor and everything went back to normal. | ELETRÔNICA NUNES |
| CCE |
HPS 2971N
|
Sometimes it doesn't turn on, when it does turn on it sometimes changes the colors | Rgb trs on tube plate unsoldered | Resolder the three | jasvan souza |
| CCE |
HPS 2991FS
|
Brightness and color saturation | Abl resistors 1k / 10 k== make adjustment in setup (service mode) in contrast and brightness) | Replace, adjust the E run for the hug. | TV TECNICA BRACEL - BRASILIA |
| CCE |
HPS 2997
TODOS |
Horizontal transistor burns out without apparent cause after a few hours | Measure the power supply, in my case it was 141 volts, I got it! should be on average 132volts | tamaralan | |
| CCE |
HPS 2997
|
Tries to arm it two or three times and it hangs up | Check 13 volts coming from the flyback, be careful with the vertical ci too | tamaralan | |
| CCE |
HPS2171
|
Image with 3 thick horizontal stripes | TV fell, you need to change the tube | marciorv | |
| CCE |
HPS2901
|
Without image, increasing scrim image with ret line and image in the background without rgb | One of the tda6106q on the kinescope board | Replace | ladmyr eletrônica universal bh |
| CCE |
HPS2901
|
Does not turn on, when turned on outside of horizontal frequency it beeps | C-429 of 220pf close to the fly back | Replace without measuring | ladmyr eletronica universal bh |
| CCE |
HPS 1407
|
TV with normal functions. Just with the screen high and it doesn't work. | Fr 901 22r on the open kinescope plate. does 180v. | JN ELET.NEVES CE | |
| CCE |
TVS-2910
|
Snoring and won't turn on or standby | Capacitor 331/2kv c402 | Replace without testing. | MARCELO BIRIGUI-SP |
| CCE |
HPS-1495B
|
TV with a reduced frame on four sides and an intermittent sparking noise near the q402 horizontal outlet, after a certain period of operation smoke starts to come out of the deflector. | Horizontal deflector with shorted turns. | ||
| CCE |
HPS 2997
|
The filament lights up and there is no image or sound | Flat that goes from the main board to the tube board, cold solder | HP ELETRONICA | |
| CCE |
2971
|
Image shifted horizontal wall bending | C-402 330pf-2kv | Barter it | WARLEY CESAR |