Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
2910FS
|
TV doesn't work and makes clicking noises at the power supply | Mf zero electrolytic capacitor | I touched and resolved | ELETRONICA MEDEIROS |
| CCE |
HPS 2981/2781
|
Does not tune channels and freezes | Exchange memory | Pcf 8582e | sotvconsertos |
| CCE |
TV 2118 USP
|
Call alone | One of the keyboard's touch keys with internal leakage | Replace all touch keys | |
| CCE |
HPS2007
|
Burning the q801 (power supply regulator) | D807 shorted | eletrojacob | |
| CCE |
HPS 2185 FS
|
Vertical venetian effect (blind) | R307 open | Replace of the same | tarcisio macedo fort-ce |
| CCE |
SS5880
|
I'm here | Replace pot volume | ||
| CCE |
HPS-2981
|
Does not memorize but tunes. | T103 | Vary the coil adjustment slightly to the left and tune again. | lou |
| CCE |
HPS-2002 =HPS-2003=2004
|
Does not connect normal power supply with 125v +b and 16v and with 15v on the collector of the normal q802 @@@ | Q802 has to reach 1 5 v at the collector | Help yourself, leave your tip ass. arni | EETRONICA ARNI-L. LEAL- SC |
| CCE |
TV-2118USP/AV
|
Closing side of the image and turning off | C417 (331, 2kv) | Barter it | Marcondes, jaicós-PI, OHM Eletronica |
| CCE |
HPS1497
|
Horizontal md1803 broken, when I switched it on, a very strong noise and horizontal md1803 heating up, it's cracked,; | Broken vertical, I changed it, the md1803 stopped heating and the noise disappeared; ♫ (very crazy). | Alextecnico | |
| CCE |
TV 2118USP
|
Turns on normally when it heats up it turns dark | Immediately replace the three df 423 on the tube plate | joão augusto | |
| CCE |
HPS2171
|
Doesn't start | C825 47mfx160v | Replace | juci |
| CCE |
HPS-2033 C
|
It turns on and works normally for a while, then loses horizontal synchronization and turns off. | Q802 bc337 | Nilson Z. Zatt | |
| CCE |
HPS-1471
|
The LED didn't turn on | Swap c808 | Replace o capacitor c808 22μF50v | mzax alves |
| CCE |
HPS 1471
|
Burns power supply transistors | Power supply ci broken | Replace the ci | Ulisses |
| CCE |
HPS 2185 FSB
|
The TV doesn't turn on. The LED keeps flashing very quickly. On the D808, the meter pointer keeps shaking and the voltage is low. | Any short exists on this line. | Remedy the short, thus replacing the component with the problem. | DANGRA ELETRÔNICA SP |
| CCE |
HPS 2971 G
|
Blue screen with a black stripe in the right corner of the screen. in the corner of the screen there is drizzle. and when you connect the antenna there is no drizzle, but the image is in shadow | Exchange r 401 of 10k | I replaced it, the problem was solved | DANGRA El.-SP 11 2012-9908 |
| CCE |
HPS 2997 FS
PCI 29 |
Cushion effect | Replace 1k resistor r 851. connect the micro pin 15 line, which forms the east-west line | DANGRA ELETRÔNICA-SP | |
| CCE |
HPS2991
|
Turns it on and off, paying attention to what channel changes alone | Short quinobs | If in doubt, replace all quinobs | celito santo angelo |
| CCE |
HPS 1491
|
No video/ 3 spots on the screen blue green red | Fr403 | 12 v. negatives | Djalma de Oliveira |