Itt Repair Tips
Search: itt
Results: 521
Results: 521
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| ITT |
CVC1100
|
Sound - weak. | C228 ( 100uf , 16v ) in cmr if. | ||
| ITT |
CVC1100
|
Small picture with hum bar. | D711 10v zener. | ||
| ITT |
CVC1100
|
Picture modulated in sympathy with sound. | T602 s/c , & check screw at rear chassis for poor con. | ||
| ITT |
CVC1100
|
No sound via vcr button. | R601 or r631 o/c. | ||
| ITT |
CVC1100
|
No sound on vcr operation. | R631 o/c. | ||
| ITT |
CVC1100
|
Distorted sound. | C228 ( 100uf , 16v ) in cmr if. | ||
| ITT |
CVC1100
|
Dead - r514 burnt up. | D504 s/c. | ||
| ITT |
CVC1100
|
Dead - no 115v rail. | Fuse o/c , d658 s/c , if run with d658 will damage crt. | ||
| ITT |
CVC1100
|
Dead - ht rail down to around 40v. | Raha (4. free) A/S. | ||
| ITT |
CVC1100
|
Dead - fuse si651 blown. | D658 ( zpy120 ) s/c. ( over-voltage protection ) | ||
| ITT |
CVC1100
|
Dead | 1a fuse o/c; bu536 s/c; d658 120v zener s/c; t713 bc328-25 leaky b-e | ||
| ITT |
CVC1100
|
Brightness low / over scanned after new loptx | The loptx just fitted is faulty! | ||
| ITT |
CVC1100
|
Blank raster & flyback lines int. | Crack in print from 12v reg on stand up side panel. | ||
| ITT |
CVC100
|
Dead with whistling only from psu | No 115v ht - 120v zener d658 leaky | ||
| ITT |
CTV1204 CVC1204
|
Dead. | Blows bu508 at switch on , check c701 for s/c. | ||
| ITT |
CT600 CVC823
|
Line pulling - two or three times a second. | Vcr switch on pb unit. | ||
| ITT |
CT600 80R
|
Line pulling or jitter intermittent. | Pk on video button - check vcr switch for grease on pins | ||
| ITT |
CT3835 COMP 80
|
Going into standby after a few minutes. | C703 ( 10u f , 50v ) little blue one. | ||
| ITT |
CT3835
|
No picture raster ok | T401 bc548 oc ( no sandcastle pulses ) | ||
| ITT |
CT3725/1 80R
|
Stuck in standby - with a noise from ltb. | D732 ( by500-400 ) s/c can use a rgp30 |