Philco Repair Tips
Search: philco
Results: 4775
Results: 4775
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
PH 21C
|
Turns on with vertical closed, then turns off | D 810-replace open diode | MARCELO JOSE | |
| PHILCO |
TTV PH 21C
|
TV does not turn on any voltage on the secondary | Zener diode 12v short non-primary d821 | Darci Fuhr | |
| PHILCO |
PH24A
|
Does not turn on, power supply stopped | C203 (2n2/ 1kv polyester capacitor) shorted | Aecio Flavio | |
| PHILCO |
PCS2956
|
Risk on the image, better known as the delay line, which is generally seen on the c728 3n3 1600v | C728 3n3 1600v was replaced | gerson tomaz | |
| PHILCO |
PH29
|
Does not turn on low power supply | Zd804 (4v7) | mega center | |
| PHILCO |
TPF-2922
|
Vertical burnt out, the biggest problem to fix, I used a similar part and it never worked. | The resistor that comes from the 50volrs of the flyback is 18r and the ci tda8177f or tda9302h there is no point in putting the tda8177 | Put the correct parts and that's it, blz | fabiusmax |
| PHILCO |
PCM-2046
|
The standby LED doesn't turn on, it's flashing, only the flyback is defective, be careful friend, even with the +b and the bu disconnected, the power supply is low @@@ | Flyback | ELETRONICA ARNI/LEOBERTO LEAL-SC | |
| PHILCO |
TPF2922
|
Burnt resistor r709 | Value of resistor r709 is 18r 1/2 if you put lower values it will burn type 1r it will catch fire | fabiusmax | |
| PHILCO |
PCM-1451
|
Call whenever you want, it seems like a bad connection | Intermittently turns on and off... | Changing capacitors c 709, c708, changing both without measuring.... | Adriano,rio verde,MS |
| PHILCO |
TPF2121
|
Altered power supply, (+ b quese 170 volts.) triggering protection. | R919 - (120k) fully open. | Carlos Maia | |
| PHILCO |
TPF2121C
|
Vertical closed | Chap. c614 shorted 47nf ceramic | Replace component note: short on the scale x1 this one is actually shorted, hugs | FABIUSMAX |
| PHILCO |
TP20V56
|
Image disappearing brightness, starting at the top, normal sound. | D 602 as leak | aelson | |
| PHILCO |
PT1410
|
Inoperative, led off. | It was the broken q901=stp9nc70zpf mosfet, ic901=ta1507p, r918=2k2 starting. I changed it and left for the hug. | ELETRÔNICA MELO BOA VIAGEM -CEARA | |
| PHILCO |
PCS-2700
|
(correction) TV without +b on the secondary, with blinking LED | As previously reported, the capacitor (c 720) is not 10uf but 47uf | Ademar / Videira sc | |
| PHILCO |
PCS-2700
|
TV without +b on the secondary, with blinking LED | Change the electrolytic capacitor (c-720) 10uf x 25v located inside the vertical heatsink | Ademar / Videira sc | |
| PHILCO |
2956
|
Turns on, turns off then arming protection | I realized that it didn't have filament protection, then I discovered that it had 180 volt protection, so I turned off the 10k r725, it worked better when reduced, I found the c1703 changed, I changed it and ran to hug it, then I turned it on to the r725 and it was fine | ||
| PHILCO |
PH21B
|
Turning off and on | Strw6553 replacement | Strw6553 replacement | fco |
| PHILCO |
TPF 2121C
|
Colored vertical lines at the top of the screen and then turns off | Capacitors c 914 and c 918, with loss of capacitance. | Replace them | ÁVILA |
| PHILCO |
PH200
PH200 |
Inoperative, nothing lights up | Audio output short tda7265 removing the ci the device turns on | Replace the tda7265 | carlosss |
| PHILCO |
TP1454
|
Normal power supply oscillates, falls and keeps turning on and off | Q901 supply regulator | Replace | EletroClaudio Aguas Belas |