Philco Repair Tips
Search: philco
Results: 4838
Results: 4838
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILCO |
PCM1451
|
Without generates and without +b. | Tda-4605-3 | Ramiro Lima | |
PHILCO |
PC1446
|
Without generating but with the normal +b, the normal 20v, just doesn't reach the collector horizontal oscillator. | Tda-8360k-4x | Ramiro Lima | |
PHILCO |
PC1444
|
Working with image, coming and going with drizzle without following the controls | C-719 almost dry 10mf- 350v. | Ramiro Lima | |
PHILCO |
PCM2044
|
With image and sound, little brightness | R-813 aberto, 680k | Ramiro Lima | |
PHILCO |
TP 1452N
|
Voltage overload on a rainy day | D 901 short | Manoel Felipe | |
PHILCO |
TP-14N
|
TV with bad tuning, image with drizzle. giving the impression that the seletronic is defective. | Change mf201 seletronic if output filter. | Joacyr | |
PHILCO |
PCM-1446
|
Stand by LED doesn't light up, doesn't turn on | Capacitor c932 | ||
PHILCO |
PCM 2952
|
Protection mode | Wide capacitors | At first the flyback had broken, it was replaced and the TV wouldn't turn on. I turned off the protection and the TV turned on with no height and width and the horizontal output transistor burned out, it was the 6n8 width capacitors. tv ok | Eli |
PHILCO |
PC-20R38
|
Dark image | C 725 open on the 180v line | AdrianChapadão | |
PHILCO |
29C21
|
Turns on and off after 3 seconds | Fly back | ||
PHILCO |
PCM 2146
CPH06 |
Image aliasing in the middle of the screen approximately 5cm wide | Transistor q 702 with minimal leakage | Replace what | |
PHILCO |
PCS-2950
|
Turns off intermittently, may take hours to turn off | Vertical output, check capacitors and ci | ||
PHILCO |
PCS-2956N
|
'turns on but doesn't oscillate horizontally | Verificar c706,c708,c728 | Marcos | |
PHILCO |
TPF2971
|
Turns on and after 5 minutes turns off and the stand by LED oscillates between green and red | C 805 with very short contacts (from the factory) and generating | ||
PHILCO |
PCM-1444
|
Stand-by LED flashing non-stop and the power supply | Replace o ic 601 (tda 3653) vertical | tony eletronica | |
PHILCO |
1443
|
It has all the voltages but it doesn't turn on | Micro clock crystal | Andrade Sequeira | |
PHILCO |
PCS-2952
|
To eliminate flash that appears when the device is turned off | Remove diode d804 from pci board | Andrade Sequeira | |
PHILCO |
PCM-2046
|
Does not turn off on the remote control | Q901, q904 shorted | Andrade Sequeira | |
PHILCO |
PCM-2046
|
When changing channels it takes about 3-4 seconds | Remove the capacitor from the aft coil, place two in parallel of 56pf+33pf, adjusting the coil this time and it works correctly | ||
PHILCO |
TPF-32S55
|
Barrel effect image | C708 shorted, c709 leaking | NUNO RJ |