☰

Philco Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philco
Results: 4838
Make Model Symptom Problem Solution By
PHILCO PC- 20R42
** 		TV out of horizontal frequency Or capacitor 303 of 47/35 votes was exhausted jaironuness
PHILCO TPF 2941
It has a power supply but no gun It fell, it was fixed, the trails worked normally; after two days it broke down, it was left alone in the waiting room carlos branco
PHILCO PCM2044
When the TV was turned on, the image was shaking, and when the volume was increased, the image was even more shaky. I checked the power supply and it was normal, but when I removed the capacitor from the power supply input I realized that it had a bad, rotten leg, the 400v/220mf c905 replaced it and went for a hug This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILCO PCM1443
Image blinking as if it were a stand by LED, normal frame, normal voltages, except video voltage; controls inoperative. R713(100k) open. Replace r713(100k), device ok. clayton
PHILCO TP1454
Problem with the colors, it remains without demagnetizing the kinescope. Check the "epcos" brand component with placement number th 901. this component is connected together with the kinescope coil. Just replace it with another one and go for the hug!!! FRANCISCO
PHILCO TPF-2901
CP01RL01 		When turned on, it displays a white screen with horizontal retrace lines and seconds later it turns off. Replacement of the 4r7 r711 that was open. Marques
PHILCO PCS 2700
The TV turns off as soon as it was turned on This TV doesn't oscillate without the fly back and without the deflector so it would be more difficult to discover the defect. But in this case it was the bad deflector coil that was causing the TV to turn off heliomar
PHILCO TPF 2130
CP 03 		Does not turn on, there is no + 14 vdc pin 1 of ic 905 Change c 918 open CARLOS ROCHA
PHILCO PCS-2976
Actuated protection It is with very high voltage C715 or c730 changed Henry Moura
PHILCO PCS 3322N
CP 01 LR02 		When turning off the power, it no longer turns on, only flashes, the power supply does not arm Next to the wide capacitor switch c728 3n3 x 1600v C728 3n3 x 1600v This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILCO PCM2976
TV turns on after + or - 30 seconds, threatens to close the horizontal and turns off. Probable cause, open power supply diode d917. amsmariano
PHILCO PCM-2046
Jagged image Interference on the kinescope PCI flat Move the kinescope PCI flat away from the flay back as much as possible. Wender
PHILCO DVT 100
Doesn't spin the disc R 23 of 1 r Replace r 23 of 1 r This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILCO PCS2952N
Low power supply hitting the power supply transformer Diode in4148 901 open julio itaguai
PHILCO TP2054
When the TV was turned on, it started to show high voltage and then turned off and did not oscillate I turned off +b from the flay back and the TV oscillated normally with the 109v input but if I turned on +b it stopped oscillating. I tested the flay back in my test and it was bad without discharge, I replaced it and everything was fine This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILCO PLATINUM TP1452N
Does not turn on, inoperative, low voltage and oscillating on the horizontal transistor collector. Change 1uf x 100v electrolytic located in the power supply. FRANCISCO This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILCO TP1452
Power supply pulsing, inoperative. Check the 1uf x 100v electrolytic capacitor at the power supply. Just replace it with another one. FRANCISCO This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILCO PCS2976S
Horizontal closing on the sides 150k resistor near d irf ,n fir horizontal plate swap Replace everything resolved MARCOS MELO CASCAVEL CE
PHILCO PCR2049
CPH06 		Turns it on after a few minutes, it turns off or you turn it off, then it doesn't turn on anymore, it only turns on after a few minutes. I verified that the horizontal output was experiencing unusual heat. I replaced the 708 capacitor (471x2kv) and that's it. Alvanyr
PHILCO TP1453
CP02RO 		Philco tp 1453 TV with a drizzled image as if high voltage was escaping and switching off intermittently, I changed the flay and cleaned the capacitors horz. R-917 2k2 Open replace do not measure on the chassis Schulz