Philco Repair Tips
Search: philco
Results: 4775
Results: 4775
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
PH21MSS
|
Turns on and off | D819 shorted | alvaro peralta | |
| PHILCO |
TV PH21MSS
|
Colored lines at the top of the vertical tele closed | R306 of 220r open close to the deflector socket | jpsky | |
| PHILCO |
TV PH21MSS
|
Colored lines at the top of the vertical tele closed | R306 of 220r open next | jpsky | |
| PHILCO |
PH21USA1
|
It doesn't turn on, the LED goes out but it doesn't oscillate, +b goes to 125v and drops until zero. | R552 of 100k and r554 of 150k open. | luis carlos [nene] | |
| PHILCO |
PH21USA1
|
It doesn't turn on, the LED goes out but it doesn't oscillate, +b goes to 125v and drops until zero. | R522 | luis carlos [nene] | |
| PHILCO |
TPF212130
|
LED on, blinking several times | Tl431 with fault ic903 | orlando lott | |
| PHILCO |
PH-21B
|
Vertical closed | Check cold solder no no jamper w-570 that powers or diode d-556 | Ademar - Videira SC | |
| PHILCO |
PH 21-SS
|
Tsound is no +b in secondary school | Change the resistors (r-552 100k and r-554 150k) | Ademar - Videira SC | |
| PHILCO |
PH-29 US-A2
|
Screen with retraces. | Check cold solder on the fly back pin that generates the 180 volts. | Ademar - Videira SC | |
| PHILCO |
PCS-2700
|
The LED just keeps flashing and it doesn't work. | Change the capacitor (c-720) 47 x 25 volts, located near the vertical heatsink | Ademar - Videira SC | |
| PHILCO / GRADIENTE |
2922
|
Does not open vertically | Change eeprom memory | Ademar - Videira SC | |
| PHILCO |
TP1453S
|
LED lights up when you press power, turns off and then starts flashing | Fly bek | Replace fly bek ov2094d1 | edezio eletronica |
| PHILCO |
PCS 2976S
********** |
Turns it on and off then note: release pin 36 from the do-it-all, the TV has to turn on with a 20 inch frame | C701 changed and c703 open, change both and everything is ok | Replace both with the same value 6k8 | ELETRONICA IDEAL |
| PHILCO |
PH14C
|
Blurred and rainbow image | Dv564 with cold soldering | Resolder | ELETROCLAUDIOPE AGUAS BELAS |
| PHILCO |
TP-1454
|
The TV was inoperative, the LED was off | F901=blown fuse, q901=2sk2740, r911=2m2, zd906=12volts, ic901=tda16846p, after changing the components the TV started working properly again. | ELETRÔNICA MELO BOA VIAGEM -CEARA | |
| PHILCO |
PCS 2952
|
Image missing from sides | R 2914 (10r 1watts) | Perto do f.back | |
| PHILCO |
TP 2010
53V |
When cold the power supply does not work | Power supply | Airton rodrigues | |
| PHILCO |
PCM 2046
|
Turns on, white screen flashes with no image | R - 715(4,7r) r - 708 (47r) | Replace the same | BARRETO CRUZ |
| PHILCO |
PH21SS
|
TV with the vertical closing with half screen, with the image shrunken. | The cause was that the vd564 and vd566 diodes were replaced without testing and the TV returned to normal. | ELETRÔNICA MELO BOA VIAGEM -CEARA | |
| PHILCO |
TV PH14D
|
Does not turn on intermittent, low supply | R839 (or r839 + r839a) of 82k and photocoupler | Baguatech |