Philco Repair Tips
Search: philco
Results: 4838
Results: 4838
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
PCS-2976S
|
When it gets hot, the picture increases and decreases, and it turns off and on quickly and remains normal. this several times. the +b voltage varies even if this symptom occurs. | R724 (10k) abl aberta. | joaomvjr | |
| PHILCO |
PCS 3300
|
Dark side stripe and little shine | Change without testing electrolytic capacitors 4.7mf x 250volts position c 853 and c 733 | eletronica valeça | |
| PHILCO |
TP2054
|
Vertical doesn't even open, changed all the capacitors in this stage, output ci, ceramic c614 that bothers and ci does everything, nothing solved | Ci voltage regulator 7809 with 1 volt less on the output pin, | Replace and go for the hug | EDGAR THIZ |
| PHILCO |
PCS2956
|
Locked without remote and panel controls | Toc keys with a lot of leakage | Replace of the 5 keys...adapt as tsound are no ones to buy. use a 4-legged standing leg. | Gersongn |
| PHILCO |
TV- PH21C
|
The LED does not turn on. | Go 01 closing short 5v. | I replaced IR 01 and everything worked normally. | COMPUHELP |
| PHILCO |
PCS2976
|
No image with sound | Cause: leaky diode 602 | klein | |
| PHILCO |
PC1443
|
On and off continuously and without characters. | 100k r713 in micro open protection line | Replace and go out for a hug | celinvds |
| PHILCO |
PH200N
XX |
The red LED doesn't even light up | Sale | Substitute o ic tda 7265 | toninho da eletronica |
| PHILCO |
TV PH29
CHINA |
Screen lights up with a black bar on the right side of the screen varying in size, occasionally serrated and turns off | Replace c450 680pf/2kv (blue) connected to the horz output collector. (blown) | JARBAS ALVES | |
| PHILCO |
TPF2130
|
Sometimes it calls, other times it doesn't | D907- r-931 | I fixed it and it was ok | ELETRONNICA AL. RAI.. |
| PHILCO |
TPF-2130
|
When you turn on the relay it keeps knocking | D-907 solve | ||
| PHILCO |
MSP211N
|
Does not turn on, LED is off | Ic301 ams1117 3.3v regulator | ||
| PHILCO |
PCS2952-PCS2700
|
No secondary power supplys | Power supply protection activated | Remove q904 for testing, if it works check the +120v, the 30v zd901, the c918 | jasvan souza |
| PHILCO |
PT-1454
|
Horizontal dark band near the left side around 3cm. | 10k x 1/4w r712 open. | To replace | |
| PHILCO |
PCR-2049
|
Image flickering, cannot adjust screen | C721 10/50v | Replace without measuring | MB ELETRÔNICA |
| PHILCO |
PH29USA2
|
No image with retraction lines from the middle to the top | Cold solder no vd564 diode | And I'm resoldering and ready | ELETRONICA AUTO TREVO |
| PHILCO |
2052N
|
Tv image a bit dark and flickering | Crista x503 and just take an older philco board and put it | MARCIORVGO | |
| PHILCO |
PCS 2700
|
Replace without testing and run for the hug!!! | Bf 423 on the fly back side + 10uf x 50volt capacitor in front of the bf, if you remove the scr from the board the TV even works but is left without protection. | Replace without testing and run for the hug!!! | EDGAR THIZ |
| PHILCO |
PC 1445
|
Does not tune channels | Ic - 102 (80011a) . memory | Replace the same | BARRETO CRUZ |
| PHILCO |
PH14
|
Doesn't start. | Memory. | If you put a virgin on, the TV turns on, however, tsound is no sound. You have to put it already recorded. | R-TEC Eletrônica |