Philco Repair Tips
Search: philco
Results: 4775
Results: 4775
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
TV-PH21M
|
Does not turn on, normal power supply | Building 804 (h, sv) | Digão Eletrônica Solar | |
| PHILCO |
PH21B
|
TV with white screen full of scratches | I short circuited the 180v line | Back to normal | fco |
| PHILCO |
TV PH21SS
|
Vertical closed at the bottom with half screen. | C 526 1000x25v, I changed it, it was fine. | Alvanyr |
|
| PHILCO |
PCS2700
|
Does not turn on, LED goes off and comes on again, does not arm. | Exhausted capacitor c711 6n8 1k6 | Replace the capacitor | eletronicaf fox |
| PHILCO |
PCS2952
|
No color | Zd504 | Eletronica Millennium | |
| PHILCO |
PH29M SS
|
Does not turn on LED blinks when pressing keys | Change the eeprom memory! | orlando lott | |
| PHILCO |
PH 14D
|
When you plug the device into the socket, the LED lights up and then goes out, but the device doesn't work - and the + b is low (+ or - 45 volts) and in addition the c 835 takes a long time to discharge. | The person responsible for all this is: r835 10r open and q881 (2n5551) shorted. | Replace r 835 (can be metal film) and q881. I also used bf422 and it worked normally. | adhemar caetano da silva (tecmil eletronica) |
| PHILCO HITACHI |
PC2035
|
Fountain beeping | C910 and/or c925 sold out. | Check the capacitors and replace them. It is recommended to check the other adjacent electrolytics. | Wiliam7745 |
| PHILCO |
PH 29 B
|
Closed image completely dark at the top of the screen until almost in the middle, at the bottom of the screen completely open. | C i ,from vertical,defective. | It was replaced and the zoom adjusted and it was ok. | Armando de Olimpia Eletronica EvoluSom |
| PHILCO |
PCM 1446
* |
Turning off with white screen with retraces on the screen | C-719 | Just your replace | wagner |
| PHILCO |
PC-20R48
CPHO2 |
Vertical linearity, stretched at the top | Electrolytic c613, 1000/25v slightly altered | Replace | jasvan souza |
| PHILCO |
TPF 2940
|
Burning r1703 dz1702 and q1701 | Bad contact cn1701 cn1702 solder directly, in my case I soldered them all, note; some technicians are reading q1701 as irf 1520 not getting the part, its specification is irfi-520n common mosfet | luismar.1 | |
| PHILCO |
TP14U56
|
LED on only turns off by pressing menu or + channel but it doesn't turn on anything on the other keys it doesn't do anything | Diode 908 | Replace d 908 | celito santo angelo |
| PHILCO |
PH21M SS
|
Turns on standby, but does not turn on | Eprom memory, I replaced it with an already recorded one and solved it | MARCONDES LIMA,Jaicós-PI- Brasil | |
| PHILCO |
TP 1454
|
Power supply stopped stand by does not light up | Replace directly without measuring d915 which powers the vcc of IC 901 pin 14 | pedrinho tela quente | |
| PHILCO |
TP29C21
|
Led power off wk +b not secondary | D915 with leak | D915 | |
| PHILCO |
TP1453
EDEZIO ELETRONICA |
Normal power supplys when turned on leave stand by and return to stand by | Fly bek | ||
| PHILCO |
29C21
|
Closed horizontal | Causes c-1706 burst and r1701 open. | Solution to replace both. | Elias Alves (Eletrônica Modelo) |
| PHILCO |
PCM 1446
|
No color | Replace capacitor ceramico c512 10k | Almiro | |
| PHILCO |
PH29US
|
Vertical closed | C567 160v 220 -d556 -d564 | ELETRONICA MARTINS UBATUBA |