Philco Repair Tips
Search: philco
Results: 4811
Results: 4811
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILCO |
PH21C
|
Turning off alone and vertical range | R 839 changed from 82k to 100k | Replace r839 82k 3w | ELETRONICA MAURI JUNIOR |
PHILCO |
TV PH21SS
|
Power supply +b reset led off | C.806 shorted | This one hit a lot | julio de itaguai |
PHILCO |
TV PH21SS
|
+b power supply with 20 volts | Bad memory | Replace directly | julio itaguai |
PHILCO |
PH-21C
|
Stained screen, with various colors. | It was applied with a demagnetizing cap but it didn't solve the problem, the stains continued, the ptc was removed and measured and it was good, | Don't test the ptc, replace it and go for it with the problem solved. | Ademar / Videira s.c |
PHILCO |
PH29US
|
Lines at the top | C 406 | Replace directly | tec center |
PHILCO HITACHI |
PC-1443
|
Dead | R902(82k) open | Replace the same | Jarbas (ELETRO-SERV) |
PHILCO |
PCS-2700
|
It doesn't work, and it smells like it's burning. | 470pf capacitor shorted | Replace the same c-708 connected to the horizontal output collector and the chassis. | Ademar / Videira s.c |
PHILCO |
TPF2121C
|
TV turns on LED presses power does not turn back to LED | Capacitor c715 low | Replace the same one for a new one! | adriano SB |
PHILCO |
TP2920
|
Does not turn on, LED flashes and the protection is activated! | D1701 short! | Replace the same | orlando lott |
PHILCO |
PH21E
|
The power supply doesn't turn on at all. This TV had already come from several workshops, they said it could only be solved at an authorized amis, when I picked it up, it didn't turn on, nor did the LED, they had already changed the ci of the tea1533 power supply, then I realized that the 3 transistors on the power supply weren't moving. | I replaced the 3 c1815 npn transistors and it worked, I ran to hug, sound's a tip file | DAVI DE PEIXE-BOI | |
PHILCO |
TP-2052N
|
Has sound and no image | Defective imaging tube | Replace the tube. | eletroclaudio |
PHILCO |
PCM 2044
|
Brightness does not work | R 124 open, close to colors | mauricio | |
PHILCO |
PH21B
|
Fully closed vertical | Yoke ou bobina vertical | On the black wire on the coil terminal solder tsound is oxidation, check diodes 566 and 564 work. with 12v only one is positive voltage the other is negative | antonio dos santos lima |
PHILCO |
TV PH29 US A2
|
Image of half of the screen from the middle up with retrace line | Resolder the drive pin called shop which outputs 14v passing through the vd564 diode | Resolder the transformer pins | Eletrônica Ceará |
PHILCO |
PH21MSS
|
Red screen with lines of retractions as if rgb resistor | Defective image tube on the red kr red pin burning the 2k7 resistor position r529 | Replace the tube. | EletroClaudio Aguas Belas |
PHILCO |
PH21MSS
|
Red screen with lines of retractions as if it were an rgb resistor | Defective imaging tube on the red kr red pin! | Replace the tube. | EletroClaudio Aguas Belas |
PHILCO |
TP2054
00000 |
Replace r919 everything came back normal | R919 changed, it is not secondary to the power supply | Replace r919 everything came back normal | marcos melo |
PHILCO |
PH21SS
|
Does not turn on, LED is off and tsound is no +b | R520, r521 e n501 | Replace them | Danieleletronica |
PHILCO |
PCS2976S
|
TV with flay back leaking high voltage | Burst pacifier couldn't find the flay back of model jf0501-2156 | So I looked for a replacement model jf0501-19277 which worked, it also works for the TV models Philco PCs 2976, 2976s, 2978, 2996s, TPF2922, TPF2121, sound's a tip for everyone | |
PHILCO |
PH21B
|
TV with sound without image, without screen voltage and when releasing the CRT board the voltage reached 400v | Loss of eprom data | Eprom rewriting | eletronica c.r. |