Philco Repair Tips

Search: philco
Results: 4811

Make	Model	Symptom	Problem	Solution	By
PHILCO	TP1453 TP1463	Takes time to turn on +b 123v when changing channel it turns off	R919 amended	Replace	tonico
PHILCO	TP29C21	Horizontal shifted to the right,(normal time, shifted time); taking up to 2 days.	Cap.smd (c705) on pin 16 of ic101 was cold soldered.	I tested it like this! , (place cap. (the defect disappears)) when (remove cap. (the defect appears)).	Alextecnico
PHILCO	TPF2121	TV only on standby, when turned on the LED blinks	After checking all the voltages and horizontal line, capacitors, horizontal output, flayback everything was ok, I then checked the 6n8 horizontal output capacitor, it had a capacitance of 3n2, just change it and run for hug	C715 capacitor replaced	Felipe
PHILCO	PCM1444 CPH05	Line standing almost in the middle of the screen, when it heats up it disappears.	A rabble	Remove the glue that remains on top of it and clean the area with isopropyl alcohol.	hndrsn
PHILCO	TV PH21B	Vertical fully closed even after changing la78040b	Measure the power supply if it is below 20v, clean the glue from the VD564 and VD566 diodes	Take the diodes out and clean the glue if possible, clean the area with thinner	antonio nobrega(patos pb)
PHILCO	TV PH21B	Vertical fully closed even after changing la78040b	Measure the power supply if it is below 20v, clean the glue from the VD564 and VD566 diodes	Take the diodes out and clean the glue if possible, clean the area with thinner	antonio nobrega(patos pb)
PHILCO	TV PH29	Doesn't start	Power supply burning the strw6556a and primary diodes and fuse.	I put the strw6556a in and it burned again, when I turned on the TV with the 150w lamp in series then the TV didn't burn the strw and showed smoke coming out of the replaced c-553 (471/1kv), changing the c-553 tv went back to work perfectly.	Adilson(formiga-mg)
PHILCO HITACHI	PC1438UO1436 CH04	Tuning goes out when turned on when it heats up normal account	Defect		abias amorim silva
PHILCO HITACHI	PC1438 CH04	Tuning goes out when it turns on when it gets hot it returns to normal	Defective tv		abias amorim silva
PHILCO	PCS 2956	When I turned it on, it turned on and at the same time turned off, that's when I realized it was entering the protection system	I removed the, q707 and it fused again		bonzinho
PHILCO	PCR2049	Has sound and no image with character	Cause: shorted 801 diode
PHILCO	PCS-3320V	Cup effect (rounded black line at the corners of the screen)	R-722-100Ω	Replace and go for the hug	samuel leite
PHILCO	PCS-3320V	Burning horizontal outlet	Fly back (ffa97017l(1) ou ffa97035l) e d707(by222)	I just had to replace them and the defect was resolved.	samuel leite
PHILCO	PCM2046	It turned on and off without stopping with loud flashes and pops.	R715 of 4.7onhs open		alvaro
PHILCO	PCM2046	After 10 minutes switched on, it disarmed with a low whistle	D302 with leaks code;1n4148 after the replace tsound was no more disarming, it was fine.
PHILCO	TP2053	Dark screen in a few moments turns off and flashes stand by	Poor contact on the cable that transports RGB to the kinescope, resolder the vertical output.		guaracy borges
PHILCO	TP 1410	When turning on tsound is sound and then tsound is no sound	Tda 7267		Matões A. Tecnica
PHILCO	TP 1410	Does not turn on stand by led	Memoria smd		Matões A. Tecnica
PHILCO	PCS2976S	LED lights up, does not activate via the power key, only via the channel key, but does not arm, just flashes once	I changed the eprom memory and it worked normally	Stay with God guys	LUIS CARLOS
PHILCO	PCM-1444 PCM-1446 PCM-2044 PCM-2046 CPH05	When entering the automatic tuning menu, it does not perform the channel search operation, returning to the menu	Memo	Replace ic memory	toninho da eletronica