☰

Philco Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philco
Results: 4838
Make Model Symptom Problem Solution By
PHILCO PC2041
No image with sound C301 0,47mf Replace juci
PHILCO PCS-2976
Just turning off, the LED blinks and only turns on after taking it out and plugging it into the socket. Power supply regulator q901 11n60 faulty Replace q901 without measuring eletrônica reis
PHILCO PH29US
Philco TV closed from the middle down Faulty memory Replace without wasting time for a new one, it can be 24c16 or 24c08 Sergio
PHILCO PCS-2952
It doesn't start, STBY LED flashing, +b voltage [120v] only drops about 12 to 15 volts. C949 [220uf/ 200v] seco. Replaced for a 470μF/200v one without any replaces. Altevirlima_Valparaiso Eletrônica_PA
PHILCO PH 21 E
Tall and short Diodo zener 5v6 (d805) oilec
PHILCO TP2054
When trying to turn on the power supply it would be normal, then it would go down and tsound would be a noise from the speakers. Transformador driver horizontal t702. @gepe
PHILCO TP-2920
TV does not turn on (inoperative) TV in stand by When turned on, the LED flashes and the power supply does not start, remaining in stand by. The polyester capacitors 1701 and 1703, both 6n8/1600v, which are located in the TV's primary power supply, were replaced. MAGDAEL
PHILCO PH 14D
Turns on the key and gets an intermittent cricket sound heating up the transistor s. horizontal Fly back with malfunction Just replace for another 0232 Cláudio Jardim Paulista Bx
PHILCO TP - 2054
With the image flickering and after a few minutes the power supply only turns off 90 volts Check the 12v zd904 zener diode To replace VERANILDOCC
PHILCO TV PH21
Does not demagnetize Rt801 ÁdrianChapadãodoCéu
PHILCO TPF2130
TV turns on normally after a few minutes it turns off, the standby LED is blinking Capacitor c 918 e fotoacoplador Replace the same TIAGO.ELETRO-PB
PHILCO TPF 2130
Closed horizontal C713 open Replace c 713 juci
PHILCO PCS3320
Reduced frame with retrace lines R708 or r712 changed palauro
PHILCO TPF2121
Doesn't work via remote Change without measuring sensor and c1102, c1103 Sensor take on toshiba u17 board and the same ELETRONICA MAURI JUNIOR
PHILCO PCM2046
No characters Zd601 apolo t.c.
PHILCO PCM2046
No characters Zd601 or some in-line component apolo
PHILCO PH200
It stays locked and the display shows the name disc L6 position smd coil Just replace and run for the hug!!! Eletrônica Áudio e Vídeo
PHILCO TP 2920
TV sometimes wouldn't turn on and tsound were thin, colored scratches on the top of the TV Capacitor poliester c1703 (6n8) marciorvgo
PHILCO HITACHI PC2004
CPH-02 		Vertical closed 5cm at the top and 2cm at the bottom. without changing the linearity or height. Vertical output transistor with changed hook. the base, emitter and collector junctions being perfect, one with gain 84 and the other 36, measuring a good one gave 33. Replace q601 e q 602. Ademir tc
PHILCO PCS 2952N
CP01LR01 		TV inoperative, burning horizontal output. When disconnecting pin 1 of the fly back (h out) the voltage of 120 volts appeared Burnt horizontal output bu2508dx, open 10r resistor 2914 and 707 diode (with very high leakage), I replaced them and the TV worked. jorgebetto