Philips Repair Tips

Search: philips
Results: 14206

Make	Model	Symptom	Problem	Solution	By
PHILIPS	FWM575	Does not turn on, all voltages ok	Panel crystal, remembering that tsound are two, one is under the panel 5406 (8,000k) and 5405 (32,768k)		HAHNRAHN
PHILIPS	32PFL5606	Doesn't start	Bad stand by power supply, chopper with internal short, burning ci pwm	This font is difficult to find, I ended up buying the font from ml for the models 40pfl5606d/78 and 40pfl5806d/78, whose std by font is basically the same, especially the choper.	davi.sls
PHILIPS	20PT326A	Blue screen, wouldn't stay on	Defect in the flyback, and in the rgb board	I replaced the capacitor behind the flyback (22μF/250v) and the resistance on the side (3.9Ω) and lowered the brightness level of the flyback to be able to leave it on (it turned off when the brightness was exposed) then the screen was blue without characters no image, only blue, 18kΩ/3w resistor (which takes the color blue) was open, replaced it and it was fine	Dvid Técnico
PHILIPS	32PFL5606D/78	Does not turn on, no stand by.	8-legged 3.3v regulator on top of main board	Interreplace 7124 and 7125 at the top of the main one, right at the entrance.	TERABYTE Guilherme Souza
PHILIPS	20PT428A/78	Image with shaky vertical lines and heating up the vertical output a lot.	C 2476 022k next vertical ci	Replace it without measuring	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	220TS	It doesn't turn on cold, it stays in a loop showing the logo and restarting	Capacitors c909, c908, c907 (330uf 35v) swollen, replace		Francis
PHILIPS	14PT3336	TV turns on normally but when connecting the antenna signal the image becomes shaky and the +b varies between 80 and 90v	After doing some tests, I was able to verify that the defect was in the 47uf x160v capacitor 2564, which had no capacitance.	After changing it, the TV started working normally again.	ASSISTEC MANARI-PE
PHILIPS	21PT8467/78	The TV has a kind of flicker, as if someone briefly raised the screen as if tsound was a bad contact on the G2.	Fly-back with faulty screen adjustment potentiometer.	Replace fly-back if this is the case. (tec, edfersom (varjota-ce)	Edfersom
PHILIPS	AZ1008/19	Disk doesn't spin	Shorted spindle motor and r3875 smd resistor 4.7Ω changed to 270Ω	After replacing the components, the disc started spinning again	Eng. Alex Macedo
PHILIPS	FWM417/78	Tsound is no sound	C760 shorted	Replace c760, f804 e f805	Eletronica Vargas RS
PHILIPS	21PT5433/78R	TV with closed screen at the bottom, does not enter the avenue.	Remove the eprom and erase it... (reset it with the eprom recorder)		J&M
PHILIPS	32PFL3403	Noise from speakers when turning on	C2420 and c2423 sold out	Replaced both	Reginaldo WK Eletrônica
PHILIPS	32PFL3018D/78	ONLY turn on the backlight with the red standby LED on steady, then turn off the backlight and standby remains on.	Corrupted flash memory. Go to the website https://microtecpg.com.br/philips-memoria-flash-e-esquemas-eletricos/ and download the data from the memory corresponding to the television display. In my case it was just re-recording another memory because hers was corrupted, it worked perfectly.		EC
PHILIPS	FWM377	No sound from bass outputs	Stand by voltage missing from STK pin 13	Q728 replaced. To clear the doubt, isolate pin 13 of the STK and inject a voltage of 1'5v. Sound should come out normally	samuel leite
PHILIPS	NX5	Fountain pulsing.	Transistor d882 open power supply position q9.		TV CENTER GUAIBA
PHILIPS	42PFL3604/78	Dead	Check c88, c89, c100, c101, c103, c104, c105, c112, c125		Gerson C.C.
PHILIPS	FWM-779	Turns on and after a few seconds goes back to standby and is stuck in standby	After turning off the power supply to the sound output and leaving only the main board connected, the defect continued, over protection being activated even with voltages all normal	Exchanging the transistor 7506 (bc847b) for a bc557, the device returned to normal	jorge
PHILIPS	32PHG4900	LEDs burn out	To reduce the voltage on the LEDs	Remove smd resistors r8614 and r8606	Paial.eletros
PHILIPS	32PFL3403/78	No sound, just a continuous knock knock knock on the speakers	Capacitors 2a04 and 2a08 of 220mf x 25v leaked, clean the board well and replace.		André
PHILIPS	32PHG4900/78	Does not tune channels- no channels found	D101, specify varicap remover	Replaced the double diode d101e c132(1nf) and the TV works normally.	Albtron Eletronica - Tatuí,sp