Philips Repair Tips
Search: philips
Results: 14241
Results: 14241
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
21PT8467/78
|
Strip of about 3 fingers on the top (vertical closing) | replace the 2 capacitors c2465 and 2446 and run to the hug | Mack Ramos. Eletronica sao carlos | |
PHILIPS |
42PFL3007/78
|
No signal or LED lights up | Tsound is no 5v at the output Replace the capacitor c9353 (330/16) | Replacement with 470/16v electrolytic capacitor resolved | |
PHILIPS |
NTRX300X/78
|
No audio | Broken 30v power supply | Check and replace 2200x50v C26 capacitors... | Medeiros Eletrõnica Barbacena MG |
PHILIPS |
32PFL5604
|
RED STAND-BY LED ON AND DOES NOT TURN ON | C474 (4,7µF/16V) | I put 10µF/16V electrolyte and works fine | RYK |
PHILIPS |
231TL4LB
|
Picture go on and go off | Coil L8708 | EletroClaudiope | |
PHILIPS |
14GL1310
gr1al |
low and rumbling sound | ts620 bc338 open | replace this transistor, check the pair ts625 bc328 in this case it was good | orlando lott |
PHILIPS |
39PFL4508G/78
L12M3.1L LA |
picture INVERTED AFTER REPLACING THE MAIN BOARD | IN SERVICE MODE TYPE ON THE REMOTE CONTROL: 062598+MENU+OPTION CODE WHICH IS ON THE TV LABEL, IN MY CASE THE TWO CODES WERE 445 BUT THE picture WAS INVERTED I TRIED 446 THE picture WAS IN THE RIGHT POSITION BUT NEGATIVE THEN I TRIED 444 AND THEN YES, EVERYTHING WAS NORMAL (WHENEVER YOU TYPE THE CODE, THE TV SHUTS OFF THEN IF IT CANNOT PROVIDE VIDEO AND JUST REPEAT THE PROCEDURE WITH THE TAG CODE | Roberto freire _ @pointinformatica6431 | |
PHILIPS |
32PFL3605D/78
slc 10.1llA |
doesn't start | c502 of 100x1kv burst, fet Q501 6nc80c and R514 of 10 homs smd. also open fuse | J.Dantex | |
PHILIPS |
42PFL3604
|
Backlight flashing | Contact lamps display | Repair connections | Angelo MG |
PHILIPS |
42PFL3008
|
It just stays on standby and blinks in the backlight | Eeprom, remove eeprom, turn on the TV without the memory, turn it off, discharge the power supply capacitors, highlight the eeprom and that's it... solved | Luiz bhtechcenter | |
PHILIPS |
40PFL5606
|
Does not turn on, does not come out of standby | Memory stuck | Short out pins 5 and 6 of the 7702 memory to gnd on the main board and connect the TV to the socket, wait a few seconds, the TV will turn on, undo the short and the TV has its memory unlocked | Mitzko eletrônica |
PHILIPS |
32PFL4707G/78
|
doesn't start | u701 regulator. 3.3 volts | Replace 3.3 volt regulator U701 on the main board | Flavio |
PHILIPS |
FX30/78
|
Dead | D3 shorted | replace diode 1n5822 no above | Rodolfo |
PHILIPS |
32PHG5813
|
Does not connect CLIETE 8817 | short diode ZD 705 ALSO REPLACE 712 IT IS THE REASON FOR THE DIODE TO BURN | REPLACEMENT . DZ705 ZENER DIODE 4V replace U712 | marcos melo |
PHILIPS |
42PFL3403
|
No sound from all outputs, including headphones. Tsound's a very soft \\\"Tic-Tic\\\" on the speakers | 2A04 and 2A08 (220μ/25v) hollow. Remove, clean and you can add PTH even respecting the height. | Mau3000 | |
PHILIPS |
32PFL5604
|
It works for 5 minutes and it beeps loudly and turns off | C474 near the u8, C527, C525 near the microcontroller, under the metal plate | HAHNRAHN | |
PHILIPS |
50PUG6654
0000 |
normal sound but no plot | broken display | I isolated the last 8 lanes on the left. Dormiuuu... good luck! | Jhone Eletronica |
PHILIPS |
FWC507
|
Display off | Resistor 4.7 position 3211 transformer board. | JMC Eletrônica e comércio | |
PHILIPS |
32MF605W
|
No sound, picture ok. | No Vcc Voltage on the audio processor. Check voltage regulator 7006 | Aaron Fresno | |
PHILIPS |
50PFP5332
|
Dead, LED flashes 6 times | Check C601 e C609 | Aaron Fresno |