☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS 42PFL5007
Pfc doesn't work Pfc ic pwm return pin activating protection Ver feedback do ic pfc GIOVANO ELETRONICA
PHILIPS 50PUG6102
No image No backlight, burning LEDs and no power supply to the LEDs Changing the LEDs, changing c8113, q8101, q8102, r8110 and r8113, removing resistors to reduce current in the 3 LEDs on each side, 8135-8136-8137 LOOPTEL
PHILIPS 42PFL3604/78
Red standby LED. When connecting via the keyboard or control, the LED goes off but the TV does not light up the screen nor does audio come out. Capacitor on main board c474 smd of 4.7uf x 16v on short. I replaced it with another 4.7v x 400v one (note: the TV is mine and as it was Sunday and this capacitor was the one I had, I ended up putting it in). Miguel
PHILIPS 32PFL5403/78
Doesn't start. the relay hits and doesn't turn on. Capacitor swollen on the inverter board. Replace it, resolved. ArnolTec
PHILIPS 32PFL3404, 42PFL3604
TCM3.1L LA 		TV does not turn on, with standby off. The power supply turns on by itself when placing the TV on the +3v3 and +24v socket connected directly, but the TV does not turn on. Defect on the main board. rewriting the memory that was corrupted, position u10 en25b32. rafaelmoraes99
PHILIPS 70PUG6774/78
Duplicate image after changing the board to another model Transfer the U409 EPROM from the original board to the new board! Right tip from Leandro Sena Tip passed on by rodrigo cofferi Rodrigo cofferi
PHILIPS 40PFL3605 40PFL3606
Tv parada, sem 3v3 stand-by D301 shorted. sb140 diode replacement Antero
PHILIPS 32PFL3404
Turns on with normal power supplys with inverter fault, lamps off Ch1/ch2 Replace the ch1/ch2 ceramic capacitor 1k Medeiros Barbacena MG
PHILIPS LE55U7970S
TV turns on, but the backlight blinks. Defect on power supply board 715g8962-p04-000-003s. the resistor r8617 was altered. original value is 0.15Ω, defective it measured 0.5Ω. I inserted a 0.1Ω resistor and the defect was resolved. rafaelmoraes99
PHILIPS 50PUG6513/78
I'm sound Defect in audio IC AD87072 48 pins Replace audio ci Claudio Jorge Eckert Junior
PHILIPS 29PT9467C
SK5 1L CA 		Image closed on the side, reduced frame Defect, replacement of cap c438, 272pf and bonina l432 next to the flyback Dj pituka
PHILIPS 43PFG6825/78
AF212121064147 		Completely turned off, it doesn't even light up 33k smd resistance connected to pin 5 of the u702 José humbeto
PHILIPS 32PFL5604
Does not turn on, the relay goes to the white LED. all power supply voltages are normal, but it does not bend pfc, Cw2 (221k-1kv) with leakage. on the power supply board. When replacing the TV it worked perfectly. Real Eléctron Carvalhos MG
PHILIPS FWM592
Turning off and heating r319 Polyester capacitor c321 dry Flavio
PHILIPS 26PFL3404
TV only turned on backlight, checked power supply without 24v and 12v 12v line in. short, check d911 if short, change and go for the hug!! Dolly
PHILIPS 42PFL3604
The 24v power supply burns out, after being repaired by the sector, it worked with a hissing sound on the t801. It was the r859 0r47/2w. 0r47 2w "wire" resistor must be installed. the squeaking disappeared. the original is made of wire, but it burned. Giovani Pires Bitencourt
PHILIPS 42PFL3403
Red standby press power turns it off but it doesn't turn on..just disconnect cn7. and calling the pw tv called back with cn7 everything came back normal Disconnect cn7 connect and return with cn7 everything was ok.. lucky for me... Helio
PHILIPS FWP2000
32v power supply with 22v Change r743 from 3k to 2k33 near tl smd and photo Warley cesar
PHILIPS 42PFL5008
42PFL5008 		TV turns on normally with no image backlight on It was changed in the service menu then it turned on normally without image backlight on You have to rewrite eeprom 464rk 24c64 position 7705 near the network cable connector - download https://www.mediafire.com/file/ya43m9kd5kp6vqj/dados_eeprom_tv_philips_placa_42pfl5008_464rk__24c64.rar/file neupsx4
PHILIPS 20PT120 20PT122 14PT120
Doesn't tune in to the channel, it gets stuck Eeprom defect [or enter service mode enter service mode by grounding pin 1 of the eeprom [or changing the memory with the recorded data[ Go into service mode and check the addresses ho 1;al 1;po 1;ac 0 checking everything and just turn off the TV using the remote control and that's it orlando lott