☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14231
Make Model Symptom Problem Solution By
PHILIPS 14PT3131
Burning the r9520 2k2 Ci smd tea1506t shorted on pin 14 Replacing the TV component was just a wire Marcos paredão
PHILIPS 32PFL4707G/78
TV turning off after a while using HDMI inputs, rear buttons not responding, after turning off in any situation you have to unplug it and turn it on again. Regulator g1084 of u701, was causing all the problems mentioned, everything working perfectly. WALTER
PHILIPS 42PF7321/78
Turns on and then turns off, the power supply LED flashes continuously Electrolytic capacitor C8057 (22µf/50v) direct replace Eletro Center
PHILIPS 52PFL8605
I retightened them all and it started working normally again. I found all the internal screws loose, loose. I retightened them all and it started working normally again. arock
PHILIPS 32PFL5606D
Does not turn on or turn on standby This is a processor initialization problem (Hercules) This is a processor initialization problem (hercules), I turned off the device, disconnected the touch keyboard and remocon cable and reconnected the device with this connector disconnected, if it turns on normally, reconnect the connector with the device turned off (of course) and plugged it in again Emerson
PHILIPS 32PFL3404/78
Turns on, everything is normal, after a while on, video disappears, sound remains, lamps on. Capacitors c532, 534, 526,528, 529. Replace them all, everything goes back to normal. arock
PHILIPS 40PFL9605D/78
Q551.1L MONET 		Disappears image, flashes image, and turns off with LED flashing 9 times. On the t-con board, check the 15v supply. tsound is a ci position switch fet1102 that stops working and does not release the 15v forward. Replace the component, or place a 1r x 1/4 resistor in place of the switching ci. Rafael do Carmo
PHILIPS FX50X/78
Turns on, the LEDs that illuminate the panel light up but the display does not light up and no function works, because tsound is a lack of 12v that goes to the front panel Diode d7, smd diode (in the body of the diode is s8) on the amplifier board, circuit that makes 12v that goes to the front panel Replacing the s7 diode with a normal her105 diode. MIGUELTV
PHILIPS 29PT5642
L0.4 		Cup effect L5403 coil with loose island Retrace the coil tracks with thread Bardock Eletronica
PHILIPS 29PT5642
L0.4 		Vertical only opened from the middle down After breaking the head, I changed capacitors, tested with another deflector, I re-recorded the eeprom, looked at resistors and diodes, but when I moved the board, the vertical one opened, I saw with a magnifying glass it had a small crack and even testing continuity with r3465 and c2463, it was good, so I made one wired jamp the tv was cool Make a jamp with wire from c2463 to r3465 this model usually gives problems with trails Bardock Eletronica
PHILIPS FWM208/55
Doesn't work No 3.3v voltage on the micro Replace of 3.3v ic 1117-33 next to ic 103 DiegoFly
PHILIPS PT3436/78
No image but with characters R3442 150k Ok video som
PHILIPS 21TP5435/78
Black stripe on the left side of the screen Memory Replace Eletronica Mauro Mascarenha. Parazinho - Ce Tel : (88) 981422821
PHILIPS 21TP5435/78
No audio and when you turn on the TV it goes into service mode Microprocessor Replace Eletronica Mauro Mascarenha. Parazinho Ceara Tel : 88981422821
PHILIPS 21TP5435
When turning on the TV, it enters service mode with a normal image without audio Microprocessor Replace Eletronica Mauro Mascarenha Tel : 88981422821
PHILIPS 29PT9457/78
Does not turn on, LED takes a while to light up and pulses Photocoupler I replaced the TV, it turned on Lucafer
PHILIPS 20PT324
Lines retracing in the middle of the image, tending to close the vertical C2409 (47x250v) HP ELETRONICA
PHILIPS DVP3120
It wouldn't open the disk access cover or turn on or give any signal After testing the power supply, a short was found in the controller; faults were found in the power and open/close buttons on the deck and the rubber that moves the disc tray was broken. Replaced everything and it works perfect again! Jailson Lima
PHILIPS 32PFL3403
TV in AV, blue screen, keyboard blocked. When turned on, it immediately turns off. Remove c2p10, 10 mf ceramic. It is next to the sensor and has no identification on the PCI. This capacitor will be leaking, killing the 3.3v from the remote control receiver. Remove the capacitor, aladim
PHILIPS 48PFG6110
Directly replace the 9311 diode Raul de saja eletronica R.E