Sharp Repair Tips

Search: sharp
Results: 1784

Make	Model	Symptom	Problem	Solution	By
SHARP	C-2053	TV doesn't turn on.	Integrated circuit IC501(TDA3653) vertical output defective.	Replace the same.	jheliocavalcanti
SHARP	29ST54	No sound, weak color and upper black band	Ic 751 9v regulator	The regulator was stabilizing the voltage at 7v	Eletronica NDN
SHARP	C-14ST58	Vertical lines at the top	Rakh 05 (AR)		HAVAI
SHARP	C-1453	Audio does not work.	Ic 301	Replace.	This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	29ST58	Burning of the horizontal output transistor and driver	1-check the value of the resistor of the base junction – emitter of the horizontal driver, which must correspond to 470Ω, changing the polarization resistor 2-in 29 st 58: r 605 from 560Ω to 470Ω; r 606 from 1 kΩ to 1.5 kΩ /4 w 3-no 29 st 98 : r 661 from 560Ω to 470Ω ; r 6l5 from 1kΩ to 1.5kΩ/4w		JOSE GUSMÃO
SHARP	20ST58	Noise at power supply on stand by	1-remove the capacitor included between pin 10 of t 3702 and q 3701, on the copper side of the PCI 2-include a capacitor in position c 3718 of 100 nf, polyester 3-include in series with the capacitor c 3718 a 10Ω resistor to ground 4-include in parallel with resistor r 3705 a capacitor of 1.5 nf x 2kv 5-in parallel with r 3727 install a capacitor of 1.3 nf x 2kv 6-in series with c 3744 add a resistor of 10Ω to land		JOSÉ GUSMÃO
SHARP	1438	Dead	C725		marcos eletronica
TVC-SHARP	C-2188 B	Image stretched vertically and shaking in the same direction	Ic 501 (la 7837) vertical exit		Adhemar Caetano da Silva
SHARP	C-2013	Sem video e osd	Flake d601	Replace d 601 1in4148	joaomvjr
SHARP	21LT45S 11AK44	Does not turn on LED turns red and green when trying to start	Problems with the power supply integrated circuit	Replace the integrated one and the electrolytic capacitor	ALACYTE
SHARP	C-20S02	It doesn't turn on, when trying to turn it on it made a small noise like a light tap on the glass and stopped!	It was just 8200pf wide 616 capacitor.		pfa
SHARP	C2092B	Vertical anormal	Causa c 510 1000/50v	Image with bar and non-standard linearity	ELETRONICA ROCHA FERNANDO ROCHA
TV SHARP	14RS03	Immediately shorting the d706 z130v	R707 33k, opened or modified..		MOURA
SHARP	14R12	Dead	Microprocessor	Hey guys, this tip is important, if the voltages are ok, with the TV plugged in, close a permanent cut between pins 41 and 42 on the computer, if the TV turns on, you can replace it.	RAIO INFOSERVISE-SP
SHARP	C2013	Noise at the power supply, TV works normally but with noise.	C735 exchange		DEBIQUE(ELETRONICA ROBSON)
SHARP	C1453	Totally inoperative, normal supply all voltages present (+115v, +14v, +12v)	R717 (22k/ 1/2 w - 1%) altered.	Attention: this resistor is critical so do not try to reuse a scrap one, use a new one and if possible with a 1% tolerance.	Altevir Lima (Valparaíso Eletrônica/PA)
SHARP	C2053	It turns off after + - 1 minute and only turns on again if you remove it from the socket, with the intervals getting shorter until it no longer turns on.	Zener diode dz606 (22 volts) with leakage.	There is no point in testing because the test appears to be normal, replace directly.	Altevir Lima (Valparaíso Eletrônica/PA)
SHARP	1413 OU 2013	TV turns on and does not obey functions, only accepts power command,	"ic 201 chroma and luminance processor", the tda 8360 does not execute the commands it receives from the computer, note, to make sure that the problem is not in the computer, measure pin two of ic 101, use a 10 volt dc scale, increase and turn down the volume and see if the voltage varies if the computer is ok.	Replace o ic 201 tda 8360	Ricardo Alves- Eletrônica do Ricardo - Caté MG
SHARP	C2041B	Vertical closing at the bottom	C507 downloaded	Replace o capacitor 1000/35v	joao gama
SHARP	2082	There was only sound on AV channels, there was no sound at all	Just exchange c311/ 103 k resolved hugs to all friends		EURIPEDES