Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV32S16
|
Vibration noise in cabinet,damaged speaker | Customer reported an intermittent noise in set usually caused by acertain sound level and tone. | ||
SONY |
KV32HSR10
|
H output transistor fail, replace t501 | H output transistor was running hot. checked waveform at h output transistor and found ringing in it. | ||
SONY |
KV27FX10
|
Intermittent bright pix, tuner also breaks up | Intermittly the picture becomes very bright with retracelines. in the tuner mode the picture will break up (like a bad if block). | ||
SONY |
KV1715
|
No audio when turned on from master swc001, c002 | When unit turned on by master switch no audio was present.turning up the volume control returned the audio. | ||
SONY |
KV13VM20
|
Ticking from power supply,q1801 touching heat sink | Ticking sound from power supply. all outputs dead.problem caused by q1801 touching head sink for switching ic. q1801 normounted in a way to make contact with heat sink but very close.repositioning q180 and adding a dab of rtv in between transistor a | ||
SONY |
KPR46DX10
|
No picture set goes into protect, crack t604/pins 6, 8 | Customer reported tv would turn on with sound, then screenwould light up bright white then set would shut off. checking for 230volts on cb board, measured on 70 volts. | ||
SONY |
KP7225
|
No power, relay won't stay closed, replace c110 | Set would turn on then within 2-3 seconds shut off.repeated attempts were the same. | ||
SONY |
KP53XBR35
|
Low high voltage, excessive width, ic805 | High voltage low and picture appeared to have excessivewidth. problem caused by ic805/n board. no pwm coming out of pin 7.115 v line not being boosted via the switched inductance circuit.replaced ic805, problem solved. | ||
SONY |
KP53XBR35
|
Intermittent no picture sound ok, cold solder on car board | Customer reported picture would black out after 20-30 mins.waiting until symptom appeared, noticed red colors in picture would getmuddy just before picture disappeared. after picture disappeared turningup the g2 controls would not produce a red raster | ||
SONY |
KP53S55
|
No picture, replace ic805 h pin controller | Set comes on, but no picture. | ||
SONY |
KP53S15
|
Unit shuts down in video mode/ adj g2 | Unit had no picture intermittently in video 1 mode. unit had no problem while in tv mode but when switch to video 1 it wouldblank out. | ||
SONY |
KP41EXR96
|
Shut off by protect mode, replace fbt | Customer complaint was set is dead. examination showed setwould power on then protect circuit would shut set off and had to beunplugged before it would power on again. | ||
SONY |
GEN-TVP
|
Anode lead part number | Replacement board does not have the anode lead with the flyback. | ||
SONY |
SPPD15
|
Distortion in speakerphone mode | Speaker phone not working right. when talking on speakerphone you hear chopped broken audio on other end. | ||
SONY |
SPPA5000
|
Unit flashes e1 in display, no other functions | At power up unit would sound an error beep and thenalternately flash e and 1 on the display. pressing any button wouldresult in another error beep. if the page and stop keys were pressedduring power up the unit would go into test mode correctly. un | ||
SONY |
ITA250
|
Main board lay out different with schematic | Tried to replace r322 but cannot, board totally differentfrom schematic. -hq comments: there are 2 service manuals, refer to the one that appliesto the unit. the 2 manuals are:9-956-098-11 and 9-956-098-12. | ||
SONY |
MDP650
|
No display - replaced c102 | Unit exhibits no display or sometimes weak display. | ||
SONY |
MDP550
|
No display- replace c102,c103,c108,c110 | Unit came in without a display. dc/ac converter not working. | ||
SONY |
MDP550
|
No display dried out cap c102 | No display, no output voltage for filament on fl display. found c102 dried out. | ||
SONY |
MDP500
|
Shuts down when powered on - c68 shorted, c151 open | Unit shuts down when powered up. |