Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
GVS50
|
Capstan runs real fast and lcd is not lit d/a conv ma137 | As soon as you turn the power on, capstan will take thespeed if run real fast. | ||
| SONY |
GVS50
|
No picture on lcd, video out ok/ solder cn901 | No picture on lcd screen but video out works fine. if tapon main board ma137 get picture intermittently, with ramdomly changingcharacters in osd running through lcd. | ||
| SONY |
TCWR531
|
No power - replaced ic801 | Unit had no power, no b+ voltage to ic801 pin 24, voltagelost across r808. unsoldered pin 24 and voltage came up across r808. | ||
| SONY |
TAAX380
|
Intermittent function switching - resoldered cnp901, cnj901 | Intermittently would not change functions. | ||
| SONY |
TAAV411
|
Unit has no audio - resoldered j501-6 ground | No audio output. audio going into ic502 was ok but had nooutput. ic502 was extremely hot. found pin 11 of ic502 at -2.1 volts.traced to ic953 and found center pin (ground) on ic953 at 10 volts. | ||
| SONY |
STRGX800
|
Hum in both speakers, all modes - resoldered c963/965 | Loud hum in both speakers in all modes. problem caused byc963 and c965 breaking loose from board. these capacitors are theprimary filters for +/-33 volt line to power amplifiers. | ||
| SONY |
STRD615
|
Dead - c211 shorting against jw350 | Unit dead, no relay. found 5v stop line at zero volts.determined line was shorted on display pcb. | ||
| SONY |
STRD1015
|
No or very weak volume - resoldered rv502 | No or very low volume, all modes may hear little volume nearmax on volume control. | ||
| SONY |
LBTG2000
|
Won't open | Won't open. | ||
| SONY |
LBTG2000
|
No cd audio - replace k103 | No cd audio with disc playing. found no audio from d-a converter, k103. | ||
| SONY |
LBTG2000
|
Tape player won't engage in play-remove excess glue from lever | A tape deck would shut off immediately when play is pressed. found excess loc-tite had dripped down from azimuth screw #357, onto lever preventing it from alinging to enable play even with no tape mounted. | ||
| SONY |
LBTG2000
|
Unit stuck in tuner mode - replace ic1002 | Unit would output only radio on cd or tuner and nothing in any other mode. found pions 9 & 10 on ic1002 switching values correct as the function switches were pressed, but ic not switching correctly. | ||
| SONY |
LBTG2000
|
No audio tape - reconnect cable from tape deck to main board | Cable that leads from tape deck to main board was not connected. | ||
| SONY |
LBTD560
|
Cd drawer won't open - dislogde carousel from spindle motor | Carousel gets caught on spindle motor making it impossible to open the drawer. could be caused by attempting to open the drawer with transport key in. | ||
| SONY |
HCDH605
|
Left channel, no audio - replaced ic401 | Left channel is out on deck a traced audio signal to ic401found no output on pin 8 of ic. | ||
| SONY |
HCDH1200
|
Error reading on display "5c5" - replaced q906 | Display shows 5c5, unit dead. cannot power up, q906defective. 12.6v supply shorted to 5.6v line. | ||
| SONY |
HCDD115
|
No cd functions no display - replace shorted q1139 | No cd functions no display. | ||
| SONY |
HCDC33
|
No power - replace f911,912, resold cold solder on cn905 | No power/ not completely, t/d has some power. | ||
| SONY |
HCDC33
|
Cd doesn't play - realign cd mech | Cd doesn't play. | ||
| SONY |
HCDC33
|
Cd door won't open - inserted and soldered +lead of c178 | Cd door wouldn't open. found c178 positive side lead not inserted thru board. |