Sony Repair Tips
Search: sony
Results: 20075
Results: 20075
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KP53XBR25
|
Anode lead assembly, not sold separately | Service manual lists the anode lead ref 128 as p/n1-559-865-41. it is not available. -hq comments: this lead comes with the crt. it was mistakenlylisted in the part list. it is not available as a separate part. this was covered in correcti | ||
| SONY |
KP46XBR35
|
Dead set, replaced ic1704 and holding clip | Set came in dead. while troubleshooting the unit, it wasnoticed that the clips holding ic1704 were missing, and the ic wasnot touching the heat sink. the ic was found to be shorted. | ||
| SONY |
KP46XBR25
|
Anode lead assembly, not sold separately | Service manual lists the anode lead ref 128 as p/n1-559-865-41. it is not available. -hq comments: this lead comes with the crt. it was mistakenlylisted in the part list. it is not available as a separate part. this was covered in correcti | ||
| SONY |
FDL-K400
|
Rubber added to stand, see correction 1 | Rubber piece added to stand. please refer to service manual correction 1. part number for rubber piece 4-033-485-01 | ||
| SONY |
ITD20
|
Part # of 4 pin line jack base 1-580-143-11 | Ordered 4 pin line jack from kc. got mistagged 4 pinhandset cord jack instead. tried reordering with same result. handsetjack arrives with the part # of the base line jack on its tag. when iorder the handset jack under its own real part 157300711, i | ||
| SONY |
ITA850
|
Pn for switches s10 and s11 on ic board | Currently, switches are not available except as part of the icboard.-hq comments: unfortunately these switches are not available separately asthe ic board has a relatively small number of components. | ||
| SONY |
ITA750
|
Pn for switches s10 and s11 on ic board | Currently, switches are not available except as part of the icboard.-hq comments: unfortunately these switches are not available separately asthe ic board has a relatively small number of components. | ||
| SONY |
CMH333
|
Intermittent power | Unit has no power. squeeze bottom of unit, power comes on. | ||
| SONY |
MDP800
|
Tray door won't open | Door won't open, just keeps flashing close on led displaywhen powered up. | ||
| SONY |
MDP500
|
Wrong ref no ic402 & ic405 switched | Ordered ic402 875205679 cxa1632q7 assuming 875904830la6510l70. ref no ic402 & ic405 were switched. | ||
| SONY |
MDP500
|
No initialization | Unit would shut down after 10 to 15 seconds. | ||
| SONY |
MDP500
|
Shuts down after 10 to 15 seconds | Unit would shut down after 10 to 15 second. | ||
| SONY |
TCWR590
|
Dead - replaced ic801 | Dead one or two segments on display lit very dim. replace cpu ref # ic801. | ||
| SONY |
TCWR535
|
Unit has no display, no function - repl ic801 | Unit has no display and no functions. main board ic801 pin71 lost -24.3v regulator. desoldered and lifted pin 71, 24.3v returnedto the line. ic801 defective caused no display. | ||
| SONY |
TCFX211
|
Capstan retaining ring | |||
| SONY |
TAN110
|
Hum in power supply - replaced transformer | Hum noise from power transformer. | ||
| SONY |
TAE80ES
|
Unit will not switch inputs - replaced shorted s101 | Green light stays on mode cd and never changes to othermodes. s101 shorted. | ||
| SONY |
TAE731
|
Intermittent right channel - resoldered ic401 | Intermittent right channel. | ||
| SONY |
TAAV670
|
Unit goes into protect at high levels - repl d801 | Unit would intermittently go into protect at higher volumelevels. found the right rear power amp to have an abnormal dc offset.changing ic851 corrected this condition but unit would still go intoprotect above 75% volume levels. d801 was found to be inter | ||
| SONY |
TAAV670
|
Unit in protect - replaced rear channel amplifier | The unit would go into protect after a few minutes ofplaying. voltage was fluctuating at the output of the rear amp driver ic. |