Sony Repair Tips
Search: sony
Results: 20092
Results: 20092
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV20S10
|
Telematic jig adapters | The following are the adapters use to connect the chassis tothe telematic jig. yoke crt vert. settings hor. settings hv 10j733 10j815 8 1.9 25k 1. vertical over scanned ho | ||
| SONY |
KV20S10
|
Specifications for the headphone jack? | The specifications for the headphone jack are missing from the s/m. -hq comments: the spec. are as follows: output impedance 47kΩ output voltage 500m vrms (100% modulation) | ||
| SONY |
KV20M10
|
Telematic jig adapters | The following are the adapters use to connect the chassis tothe telematic jig. yoke crt vert. settings hor. settings hv 10j733 10j815 8 1.9 25k 1. vertical over scanned ho | ||
| SONY |
KV20M10
|
Specifications for the headphone jack? | The specifications for the headphone jack are missing from the s/m. -hq comments: the spec. are as follows: output impedance 47kΩ output voltage 500m vrms (100% modulation) | ||
| SONY |
KPR46EX35
|
No pix has sound, resolder l1306 | No pix but has sound. all supply voltages ok. no voltage onpin 34 of ic304. | ||
| SONY |
KPR41EXR95
|
No picture, replaced e1 board | Set has a no picture and on screen display, but sound is ok.deflection and hv voltage circuits functioning properly. no video at r, gand b outputs at connector e1-24 pins 3, 4, 5. y and c entering e1 boardfrom a board pins 46 and 44 at connector e1-00 | ||
| SONY |
KPR41EXR95
|
No picture no functions, leaky diode d211 | Set displayed symptoms of no picture, would not accept anycommands. checked u board, no video coming from tuner or video inputs.no data at pin 20 of ic1002(audio video signal selector).i found data bus throughout set loaded down to approx .4 volts. | ||
| SONY |
KPR41EXR95
|
Hv shutdown, leaky cap c818 | Unit would go into hv shutdown when turned on. duringmonitoring discovered hv portect detector ic804 pin 1 was latching highwhen unit was turned on and monitored b+ boost at cathode of diode d801,found climbing over 160 volts. checking hv regulation de | ||
| SONY |
KP61V15
|
"d" and "ds" board changed, refer to the kp-46s55 s/m | The service manual shows the ds board has three ic mountedon it. the one in the unit only has one ic. -hq comments: both the d and ds boards have been changed. theyare not interchangeable. please refer to the kp-46s55 for the correctschematic, page | ||
| SONY |
KP53V16
|
"d" and "ds" board changed, refer to the kp-46s55 s/m | The service manual shows the ds board has three ic mountedon it. the one in the unit only has one ic. -hq comments: both the d and ds boards have been changed. theyare not interchangeable. please refer to the kp-46s55 for the correctschematic, page | ||
| SONY |
KP53V15
|
"d" and "ds" board changed, refer to the kp-46s55 s/m | The service manual shows the ds board has three ic mountedon it. the one in the unit only has one ic. -hq comments: both the d and ds boards have been changed. theyare not interchangeable. please refer to the kp-46s55 for the correctschematic, page | ||
| SONY |
KP46V16
|
"d" and "ds" board changed, refer to the kp-46s55 s/m | The service manual shows the ds board has three ic mountedon it. the one in the unit only has one ic. -hq comments: both the d and ds boards have been changed. theyare not interchangeable. please refer to the kp-46s55 for the correctschematic, page | ||
| SONY |
KP46V15
|
"d" and "ds" board changed, refer to the kp-46s55 s/m | The service manual shows the ds board has three ic mountedon it. the one in the unit only has one ic. -hq comments: both the d and ds boards have been changed. theyare not interchangeable. please refer to the kp-46s55 for the correctschematic, page | ||
| SONY |
KP41EXR96
|
"d" and "ds" board changed, refer to the kp-46s55 s/m | The service manual shows the ds board has three ic mountedon it. the one in the unit only has one ic. -hq comments: both the d and ds boards have been changed. theyare not interchangeable. please refer to the kp-46s55 for the correctschematic, page | ||
| SONY |
FDT5BX5
|
Deflection yoke part number, comes with crt | There is no part number in manual for deflection yoke. -hq comments: this yoke is only sold with the crt as one piece. alladjustments are done at the factory. | ||
| SONY |
SPPX90
|
Customer complaint of no range | With a customer complaint of no range the control button boardwas replaced. it showed evidence of damage due to arcing or possiblychemical damage. this is the second instance of this problem we have seen.the defective board is being forwarded for your in | ||
| SONY |
SPPX90
|
Excessive static | Too much static. -solution : resolder ic401 (signal processor). | ||
| SONY |
SPPX30
|
Loud hissing in handset and excessive background noise | Customer complaint static, hissing or can't hear caller well,noise. found cause to be an overly sensitive w/s mic circuit. triedseveral different resistor values/combinations at r17 and r25 to find themost effective fix. | ||
| SONY |
SPPS10
|
Incorrect part for mag plate | The mag plate bearing this part # does not fit the spps10. ithas tabs and also is larger than the s10 plate. please assist indetermining correct #. -hq comments: per kcp: by carefully cutting off the tabs, the plate willfit fine. | ||
| SONY |
SPPA20
|
Handset fails rx sinad | Hand unit fails rx sinad. |