Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV27TS36
|
Jvc and hitachi codes missing from owners manual, see below | Customer could not get their jvc vhs deck to operate usingthe code 16 as stated in the manual. noticed their rmy-113 remotestated to use either 16 or 35. when they tried code 35 it worked. | ||
| SONY |
RMY118
|
Jvc and hitachi vcr code, code 35 and 36 missing from o/m | Customer could not get their jvc vhs deck to operate usingthe code 16 as stated in the manual. noticed their rmy-113 remotestated to use either 16 or 35. when they tried code 35 it worked. | ||
| SONY |
GV8
|
No on screen display/check fp-133 flex/30v line | No on screen display. could not determine why it was not working. | ||
| SONY |
KV32TW78
|
Loses audio after warm in tuner mode only, replaced tuner | Loses audio in tuner mode only, video and audio input does not cause loss of audio. | ||
| SONY |
KP46XBR25
|
Dots in picture in bright scenes, replaced p4 board | Unit had uniform pattern dots in picture in all parts of picture that were bright. only in tuner and video mode not in s video or pip mode. | ||
| SONY |
KV27FX10
|
No power, replaced thermistor | No power, 7 amp fuse (f651) open. found fuse open but, couldnot find any shorts. disconnected r652 and the degaussing coil. ifconnector f-4 was disconnected, 05 and 12 volt supply came up, fuse didnot blow. connecting external 16 volts to r656/d652 ju | ||
| SONY |
KV32XBR95S
|
No audio except fixed monitor output, replaced x3 board | No audio execpt from fixed monitor output. | ||
| SONY |
CFS730
|
No motor functions - replace c373, p/n 1-126-176-11. | Radio section, amp work ok. no cassette power. motor b+ islow. found c373 shorted. after replacing the cap, ifound that the voltageon the 10v rated cap was 9.2 volts. | ||
| SONY |
TAAV421
|
Intermittent audio - speaker relay not turning on, cn18 | Unit would work fine but would intermittently, while playingaudio (ry701), go on and off. | ||
| SONY |
SLV555UC
|
Tape does not eject properly:-clean dried grease from 163 | Tape does not eject correctly. grease on rvs arm assy ref 163has dried and become sticky. the arm stays in the loaded positon andprevents tape from ejecting completly. | ||
| SONY |
CCDFX410
|
Different cs 31 board/enter page d data | Orig. bd is p/n 1-642-172-14, new bd is p/n 1-642-172-12.when the power sw is in any position, the camera is on. if you put a tapein, hit stop, then play, a tape will play. if you stop, then hit record,the unit goes in record. please advise asap. -hq | ||
| SONY |
EVC100
|
No playback video: replace fl-604 on vi-123 bd | No video on playback. sound ok, e-e video ok. | ||
| SONY |
KV32XBR51
|
Static, see flash 92r1 | Terry williams informed me of another static problem. thesympton was bringing up the video menu, the set would shut offmomentarily, then turn back on in the rf mode. | ||
| SONY |
CCDF201
|
Playback brightness too high/ic203-cv-8 bd | Playback brightness too high. could not be corrected withservice adjustments. point to point signal tracing suggested ic203 wasdefective. -solution : replacement proved that to be true. -hq comments: ic 203 is the y/c processing ic. | ||
| SONY |
CCDF56
|
Intermittent tape transport/replace c501 | Intermittently unit would not transport tape. it would faultflag, no reel sensor. actually, the capstan would fail to turn. caused byc501 intermittently shorting down to 40kΩ, stoppping capstan drive. -hq comments: c501 smoothes the servo 5v line. a | ||
| SONY |
TCDD3
|
Intermittent popping noise (resolder c548 on main board) | Intermittent popping noise, when lid tapped, or by itselfafter 15 or 20 minutes. this was caused by a poor solder connection atc548. -hq comments: c548 is one of many de-coupling capacitors found connectedbetween the +5v line and ground. the intermitte | ||
| SONY |
CCDTR101
|
Lens hunts in pitch direction/replace se-22 on se102 board | Servicer found that with camera on and at rest, it would huntup and down slowly. we ordered se-22 mcb, thinking the sensors wereincluded, but we found otherwise. found p/n above in misc. section, andreplacing part cured problem. -hq comments: se-102 is | ||
| SONY |
CCDV5
|
Intermittent rainbow in video/lap heads | Customer complained of glitches and distortion in pix. atfirst servicer found loose guides and also adj tape path. then he noticedintermittent rainbows and a vertical bar on self-recorded tapes. he re-soldered connections on mr-8 board and unit seemed | ||
| SONY |
KV27TS32
|
Popping sound when channel changed, no solution | The atlanta ssc made a service call on this set.adjusting the bass control, ref fpr o2181, did not eliminatethe problem completely. the dealer refunded the customersmonies after exchanging it three (3) times. -hq comments: we are aware of the problem, b | ||
| SONY |
ITA3000
|
Mislabeled ic in block diagram - ic306 should be ic806. | In the block diagram on page 35 of the service manual forita-2500/a3000 (9-957-952-11) ic306, should be ic806. -hq comments: thanks for the info. it will help other techs. |