Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
FDL380
|
Screen would only play for 15 seconds, fluorescent tube | The set would run for fifteen seconds before it would blackout. the fluorescent tube would darken on end and protection circuit would kick in. | ||
SONY |
KV13EXR91
|
No remote operation, replace detector ic103 | I checked the voltage to ic103 and gnd and it was fine,but there was no signal out. | ||
SONY |
KV2691R
|
Set shut down at start up, open c609 | I found a ripple on the retified standby line. | ||
SONY |
STRD790
|
No surround - r628 faulty p/n 1-249-389-11 | No surround at all. | ||
SONY |
KV32XBR25
|
Intermittent pix, resoldered q2303 on "e2" board | Intermittently there was no video, channel display o.k. | ||
SONY |
KV27TS27
|
No video, replace ic-301 | There was no video, raster (dark) intermittently. the soundwas fine though. | ||
SONY |
KV20TS27
|
No power, replace ry601 | No power. | ||
SONY |
PVM2530
|
Retrace lines, top of picture | The picture was distorted with retrace lines on the top. | ||
SONY |
KV13TR27
|
Snow and no display, resoldered 5v regulator ic | There was no picture instead, raster and snow appeared. inaddition, there were no channels or volume display. | ||
SONY |
CPD1302
|
Shuts down immediately when rgb cable is connected to pc | The unit would shut down immediately after the cable was connected to the computer. | ||
SONY |
CPD1604S
|
Intermittently loses green, cold solder on r526 on "b" board | The monitor would intermittently lose green. | ||
SONY |
STRAV920
|
Display out but operation ok - faulty solder r202,203,242 | The unit had no display, however, operation was normal.tapping around the left front part of the unit caused the display toflash. | ||
SONY |
SLV585HF
|
No drum rotation. eats tapes./ cn007 md49 board loose. | No drum rotation and it ate the tapes when the tape was loadedand play was hit. | ||
SONY |
SPPA20
|
No range | There is no range from the handset. | ||
SONY |
ITA550
|
Inoperative - replace ic-203, p/n 8-759-945-88 | Inoperative, and the ac adaptor (ac-t145) was getting hot. | ||
SONY |
CCDV5000
|
Auto focus question | We need to know at what point the auto focus sets the lens ata fixed point when in wide angle zoom. we cannot locate this informationin the service or owners manual. are we overlooking it or does this modelhave a different mode of operation?? please l | ||
SONY |
CFD440
|
Cd not operational - replace ic-802, p/n 8-759-971-11 | No power. i only repair cd mechs, and of the ones i do, about1 out of 20 has this problem. | ||
SONY |
CDP297
|
Intermittent power or no power, replace c105 p/n1-135-155-21 | C105 on bd board has been installed in reversed polarity whichcauses the unit to switch off after a few seconds. in some cases the unitplayed for about a minute and then lost power. | ||
SONY |
CFD440
|
Shuts down after severe shock-bend s-704 leaf switch/cd door | When checking cd units, we do shock tests. when shocked, thecd stops playing and shuts down, and the display shows 00. the shocktest is for checking to see if the unit comes back to the original spot ofplay after it is shocked. it is shutting down and | ||
SONY |
MZ2P
|
Won't eject disc: shutter blocks opening (re-adjust ref. 59) | Several units have come in with discs stuck in the mechanismwhich could only be freed up by disassembling the cabinet and moving thereddish brown shutter panel out of the way while activating eject. |