Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
SLV585HF
|
Door not opening when eject is pushed | When eject is pushed, door would not open to let tape out. | ||
| SONY |
D66
|
No volume on right side - replace q-201, p/n 8-729-921-72 | Left side volume worked and the right side did not. there wasno signal on ic-303/pin 3. traced the problem back to q-201, the mutingtransistor. | ||
| SONY |
CCDF56
|
Mechanism loads, goes into play and record without a tape | Unit would load without a tape and go into play and record.had several units with the same problem. technician had changed reelsensors and end sensors without correcting the problem. i repaired theunit by changing the mode control cpu on the fu-72 board, | ||
| SONY |
CCDF301
|
Mechanism loads, goes into play and record without a tape | Unit would load without a tape and go into play and record.had several units with the same problem. technician had changed reelsensors and end sensors without correcting the problem. i repaired theunit by changing the mode control cpu on the fu-100 board | ||
| SONY |
SLVR5UC
|
Intermittent autotracking | Both customers complaints were that after forward or reverseunit would mistrack severely (looked like tracking was set all the way tothe end). also pertains to serial number 824601. | ||
| SONY |
HSTD105
|
Audio cuts out | Audio cuts out after approximately 5 minutes operation atmoderate volume. | ||
| SONY |
TAAV421
|
Cd player attached cannot be turned on or off | The associated cd player, cdp-221, could not be turned on oroff. leaky q-110 in the ta-av421 was holding the cd control line in itsoff state. | ||
| SONY |
CCDTR55
|
No luminance | Although offshore model, information applies to our ccd-tr55.symptom of no luminance. chroma slightly visible. voltage at pins 36 and38 of ic-301 read a low .9v. | ||
| SONY |
CCDTR200
|
No video - only noise | Unit from ft. lauderdale ssc. had no picture, sync on wfmlooked unstable and wrong frequency. | ||
| SONY |
CFD757
|
Inoperative set - replace q-308, p/n 8-729-902-80 | Set was inoperative. no standby 6v was in evidence. bysubstitution, q-308 proved bad. | ||
| SONY |
HCDD117
|
Speed adjustment and high w&f | Speed adjustments and high w&f. high use of motor onhst211, hst221, hstd105, hstd107, hcdd117. all use potentiometers onthe cassette pcb to adjust speed. hcdd115 uses the vr inside the motorto adjust speed. | ||
| SONY |
HSTD107
|
Speed adjustment and high w&f | Speed adjustments and high w&f. high use of motor onhst211, hst221, hstd105, hstd107, hcdd117. all use potentiometers onthe cassette pcb to adjust speed. hcdd115 uses the vr inside the motorto adjust speed. | ||
| SONY |
HST221
|
Speed adjustment and high w&f | Speed adjustments and high w&f. high use of motor onhst211, hst221, hstd105, hstd107, hcdd117. all use potentiometers onthe cassette pcb to adjust speed. hcdd115 uses the vr inside the motorto adjust speed. | ||
| SONY |
MPKTR
|
Wrong part number for pedestal base | Part number for pedestal base reference number 121 is wrongalso part number for reference 118 is missing. | ||
| SONY |
SPP150
|
Won't lock on channel | Would not lock on channel. checked and found frequency off.tried to adjust ct-301 to no avail. when trying to adjust it, it seemedto skip over proper frequency. | ||
| SONY |
CDXU300
|
Does not read discs | Unit would not read toc. the sled motor was running butthere was no fop movement. the drive base had slipped out of place. | ||
| SONY |
XRA55
|
Request for part registration: gmd-314 mounting sleeve | Reference no. 63 and 64 are listed separately on page 28 ofthe service manual. they are available through sales as gmd-314 as thecomplete bracket. can national parts center register and order thecomplete gmd-314 for stock? -hq comments: we have forwar | ||
| SONY |
CCDFX510
|
Crackling noise in audio playback | Crackling noise in playback only. most evident in low notes. | ||
| SONY |
GV300
|
Curl at top of picture | Unit came in with bad heads. replaced upper drum and picturewas restored. however, there was a curl at top of picture during playbackand was especially pronounced during still and slow-motion. tape path waschecked as was head switching. the still/slo | ||
| SONY |
GV300
|
Slow-motion and still picture distorted | In still picture and slow motion picture was distorted withwhite lines etc. this was not corrected with the still/slow buttons. tapepath and head switching position were correct. cue and review were ok.the problem was mostly evident on tapes recorded in |