Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
CCDTR51
|
Shorted c-154 on "vs-77" board | Unit is inoperative. | ||
SONY |
CCDFX410
|
No camera mode | Unit would playback fine but would shutdown in camera mode.if i removed the ccd block, the unit would not shutdown. i tried anohternose assembly and the unit shutdown once again. found the 15 volt linecorrect but the -9 volt supply going to the imager | ||
SONY |
CCDF401
|
Date positions switched | Camera would not come on. date on side display of unit wasout of position ie. 1993, march 24. the title function indicator wouldintermittently flash. after received in shop, the unit would workintermittently, but the above symptoms remained. | ||
SONY |
SLVR5UC
|
No e-e video from l-1 input | Unit had tuner video in ee mode. when switched to l-1 on l-2video input there is no video out or rf out. | ||
SONY |
CCDV5000
|
No color gain | Weak, light color no yellow color only. if view with colorbar test chart no awb or manual white balance function. | ||
SONY |
CCDF33
|
No playback | Unit would record but not playback. if i disconnected pin 16of ic-201 on the cv-8 board (horizontal blanking from ic-502 forcharacter insert), normal video and sync and separate composite syncsignal not locked to the video appeared on the scope. in playb | ||
SONY |
CFSW420
|
T-reel assembly shaft breaks off chassis | T-reel assembly shaft breaks off from chassis assembly. weakat base and shaft is hollow. | ||
SONY |
CFSW320
|
T-reel assembly shaft breaks off chassis | T-reel assembly shaft breaks off from chassis assembly. weakat base and shaft is hollow. | ||
SONY |
CFD20
|
T-reel assembly shaft breaks off chassis | T-reel assembly shaft breaks off from chassis assembly. weakat base and shaft is hollow. | ||
SONY |
KP5000
|
No control of hor. keys or horizontal size, replaced d-5303 | Does not control horizontal keys and horizontal size. | ||
SONY |
CCDFX510
|
Shut down during play | Intermittent shut down during play. also mechanical noise.found evf position lock comes off and that part falls into drum motorarea. | ||
SONY |
EDV9500
|
Intermittent cassette jam | Unit had been in the service center several times forintermittent cassette jam problem. customer would depress the ejectbutton and occasionally the mech would bring the tape back into thecassette but the tray would stop before fully ejecting the tape | ||
SONY |
XR5500
|
Tape deck motor runs constantly | Tape motor (m-900) keeps running, even during radio play. | ||
SONY |
STRAV710
|
Distorted fm - ic21 defective (p/n 8-759-821-45) | Fm mode is distorted. all other inputs are fine. | ||
SONY |
STH3600
|
Dim display due to open resistor on ta-h2600, r953 | When tuner is checked with test jig of a test until, it works fine. when hooked to its own amp the display is very dim. | ||
SONY |
TAH2600
|
Dim display on tuner - replace r-953, p/n 1-216-025-00 | When tuner is attached, display is very dim. cassette and ampdisplays are fine. checked all voltages to tuner and all were good. | ||
SONY |
CCDTR81
|
No video in playback | Unit has e e video but none in playback. | ||
SONY |
DD1EX
|
Will not read disc and has heavy current draw | Unit will not read disc and while trying draws heavy current,pulling voltages low and causing display to blink. suspected optics butreplacing it produced no change. checked spindle motor and found it to be1Ω and is supposed to be approximately 8Ω | ||
SONY |
CCDFX311
|
Won't load with a tape in unit | Intermittent no drum on or improper drum speed. | ||
SONY |
HST201
|
No power - d907 faulty causing loss of +5v (b+) | No power and no functions. |