Search: sony
Results: 20075
Make Model Symptom Problem Solution By
SONY SLVR5UC
No video When in the pb mode, sound is heard from the tape but thevideo is coming from the tuner (looks like a switching problem). checkingthe pb-y-fm signal at cn-202 on the rp-76 board, you observe 50mv ofnoise which leads you to believe the problem is with th
SONY PVM2530
Excessive overdrive in whites San diego ssc and the servicing dealer were battling a problemwith excessive overdrive in the whites. the whites were turning silver.found video input line not terminated.
SONY XR7280
Ams doesn't work Ams has never worked on customer's unit. customer took histapes, pre-recorded and home-made to the store where he bought his unit.the demo unit didn't work either. audio output from eq ic is about 500mv.pulse to pin 72 appears when tape passes blank pr
SONY CCDV11
Ls chassis change According to service bulletin number cam0144, the ls frame nowbeing supplied for the ccd-v11 is the above number. servicer indicatesthat there is no way to install the old upper cabinet assembly on the newls frame. does the ccd-tr5 cabinet fit or can t
SONY KV20TS20
Lines across screen, leaky c-535 Lines across screen in lower half of picture. on screen dis-play of channel number showed in bottom right corner of picture as well asupper right corner.
SONY CDPC305
Wrong part for disk table When she ordered reference no. 52, (2 hole type) and receiveddifferent type of table assembly (looks like cdp-c400 one hole typetable). this is according to cathy in pittsburgh. i looked up pmi and<-28> on display (national backorder).
SONY CDPC205
Wrong part for disk table When she ordered reference no. 52, (2 hole type) and receiveddifferent type of table assembly (looks like cdp-c400 one hole typetable). this is according to cathy in pittsburgh. i looked up pmi and<-28> on display (national backorder).
SONY CCDF77
Capstan run away Found capstan would intermittently run away.
SONY CFSEW60
Part numbers missing in service manual Are the following part numbers available or should we orderthe md sub assy, ref 361, page 22 of service manual, p/n a-3213-793-a? -hq comments: we will check with tokyo.tokyo fax (a911045) the parts are available as follows:a. x-3391-015-1 assy te
SONY CDXA15
When using controller, display says wait - no operation If using the rm-x2, when play is pressed the display indicateswait. after 5-10 seconds, the unit starts to operate. when using anxr-7400 to control the unit, the changer will not operate and there is noaudio output from the xr-7400 in any mode.
SONY TAAX301
Distorted audio at 3/4 volume left channel Distorted left channel at higher volume only. at normal vol-ume would sound fine.
SONY STRAV1020
No surround output at all; a and b ok Had signal going to ic-504, nothing coming out.
SONY STRD2020
Hiss sound on surround rear speakers after 30 minutes All speakers play good however, after 30 minutes the rearsurround speakers would gradually start hissing noise.
SONY FD500
Unit inoperative when picture switch is in the on position Unit goes dead in any function mode when picture switch is inthe on position. with the picture switch in the off position unit willoperate if power is recycled from off to on (still no picture). when unitgoes dead, no b+ can be measured at q-601 collec
SONY MDP210
Will not play ld's but plays cd's When attempting to play on ld, unit will spin disc rapidly(run up mode) brake hard and run up twice more. rf will appear brieflybut ld will not play. cds play fine.
SONY CFSW501
Fm not tuning standard 88-108mhz band After replacing ic-601 (controller) the set would not tune thestandard fm band. it tuned from approximately 65mhz-90.1mhz only.
SONY CCDV701
Part number for ir receiver What is the part number for the ir receiver ic sbx1619-51?
SONY WMF80
Band selection knob part number is wrong Servicer ordered knob by number in manual. could not accesstv mode due to physical obstruction. parts fiche says this is for awm-f77. there is another part number 3-335-732-01 with a description ofknob (c), tuning, that the parts fiche claims to be pa
SONY CDPC505
Drawer won't open Drawer won't open. +10 voltage is low at ic-903 pin 1.
SONY KV32XBR15
Buzzing on channel 11, add attenuation Buzzing noise on channel 11 (sunshine cable) which gets worsewhen srs system is on. tried a working kv27xbr in customer's home and italso does the same thing. customer had another brand name set which ihooked up to the same cable outlet and had no prob