Sony Repair Tips
Search: sony
Results: 20075
Results: 20075
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV13TR10
|
Intermittent white picture, replaced the if block | Picture would intermittently go white. found if block defective. | ||
| SONY |
CDPC215
|
High pitch noise from line out and headphone out | Flex cable ref. 6 insulation tears and shorts to chassiscausing a high pitched noise from the line out and headphone outputs. thedisplay is also irratic. | ||
| SONY |
KV13TR24
|
Intermittent sound, replaced the if block | Unit had intermittent sound. traced problem to if block. | ||
| SONY |
KV19TS20
|
Sound goes off - stays on one channel, replace tuner | Sound would intermittently go out, also the set would stay onone channel and had distortion in picture. traced problem to defectivetuner. | ||
| SONY |
KV32XBR10
|
High pitched oscillating sound, replaced r-527 | High pitched oscillating sound from the set and poor interlacei.e., looks like horizontal line pairing. waveform at pin 1, a-84 connec-tor was 25vpp, horizontal amp waveform at pin 11, t-500 fbt was 225vpphorizontal. inspection of r-527 revealed it was | ||
| SONY |
KV20EXR10
|
No rastr - no sound, replaced r-567 | No raster and no sound. faint line horizontally scrolling from top to bottom of screen. | ||
| SONY |
KV32XBR15
|
Channel changes by itself, replaced ic-1701 | Channels keep changing by themselves. | ||
| SONY |
KV32XBR15
|
No picture or sound, replaced ic-442, and ic-443 | Change ic-442 and ic-443. data line was grounded. disconnec-ted pin no. 10 (sdt) on both ics. set will operate. -hq comments: thank you for your report. please check the cause of theshort circuit next time and report to us. | ||
| SONY |
KPR36XBR
|
No crosshatch, check circuit ic-8005,002, crystal x-1 | No crosshatch, replaced da and db boards to no effect.voltages a tps seem to be good. -hq comments: da board only contains the switch for turning thecrosshatch on, or off. db board does not contain any crosshatch cir-cuitry. crosshatch circuitry is loc | ||
| SONY |
FD555
|
Vertical collapse | Picture would collapse vertically after warm-up. tubedburned. | ||
| SONY |
GV9
|
No sync in lcd display - video out display normal | The lcd display was scrambled in e to e or playback. on external monitor hooked to the video out had a normal synced picture. | ||
| SONY |
CDPC900
|
Won't count in fast foward scan | When you fast foward scan, unit stops counting and appears tomove forward faster than reverse scan which works ok. -hq comments: we would recommend checking pin 20 of ic-201 with youroscilloscope. look at the output to the sled motor drive chip (ic-202 | ||
| SONY |
CCDTR7
|
Different "vs-61" board than the manual shows | We have a report that the parts layout is different thanservice manual shows. particularly, certain resistors and capacitors arenot located where the board layout shows them to be. do you have anupdated board layout drawing you can send us? thank you | ||
| SONY |
HST201
|
Service manual descrepancies - s902 and s904 | The service manual shows two switches (s902 - a deck/s904 - bdeck) which are not actually in the unit. the pads where the switches aresupposed to be are jumpered with solder. this results in the capstanmotors running constantly as long as the system is | ||
| SONY |
KV27XBR15
|
Very weak vertical sync, replaced q-301 | Very weak vertical sync. | ||
| SONY |
WMDD1
|
Intermittent shut off | After playing about 10 seconds, the unit will shut off. | ||
| SONY |
PTB500
|
Part number | The part number of the ptb500 is j-6029-140-b. it isavailable from kansas city parts. | ||
| SONY |
VCLG1
|
Part number for adaptor ring | Is there a separate part number for the lens adaptor ringincluded with this lens kit? thanks in advance for your help. -hq comments: part number is 2-395-038-01. | ||
| SONY |
GV200
|
Part number for a/v jack cover | Regarding the gv200 and gv300, is there a part number for thecover (supplied with the machine) that goes over the a/v (rfu) jacks onthe side of the unit? -hq comments: part number for the gv300 cover is 3-744-118-01. thiscover is not supplied with the | ||
| SONY |
KV32XBR70
|
Blanked picture - loud static noise, replace s-54 | Power can be turned on/off from front panel only. no otherfunctions. very loud static noise and no audio. |