Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CFD760
|
Service mode does not work | Cannot check sled motor or focus search when in service mode.i have checked two units and get the same response. -hq comments: the procedure shown in the service manual for entering theservice mode is incorrect. to enter the service mode, make sure pow | ||
| SONY |
TCWR510
|
Missing part number | The spring does not show on the service manual. -hq comments: the spring in question is ref. number 56, part number3-391-096-01. the other springs are part of the md sub assembly and arenot listed separately. | ||
| SONY |
SPP110
|
Part number of fuse not listed in service manual | I couldn't get serial number but some spp-110s have fuse(ref no f-101) between l-604 and vdr601. need supplement and part number. -hq comments: you were looking at the spp-110/150 service manual whichdoes not include the fuse. please look at the spp-1 | ||
| SONY |
CCDF55
|
Ccdf55 shutdown problem | |||
| SONY |
SPP150
|
10.24 mhz crystal replacement does not fit | When ordering and inserting a new 10.24 mhz crystal, the newcrystal does not fit in the handset. -hq comments: the reason for this is that there were originally 2 sizes:a short one for the handset and a tall one for the base. however, theyboth have the | ||
| SONY |
SPP110
|
10.24 mhz crystal replacement does not fit | When ordering and inserting a new 10.24 mhz crystal, the newcrystal does not fit in the handset. -hq comments: the reason for this is that there were originally 2 sizes:a short one for the handset and a tall one for the base. however, theyboth have the | ||
| SONY |
SLV676UC
|
No functions after unpluging and re-inserting ac plug | All functions are disabled after pulling the ac plug thenplugging it back in again. | ||
| SONY |
SLV575UC
|
No operation after pulling and re-inserting ac plug | All functions are disabled after pulling and re-inserting theac plug. | ||
| SONY |
CCDV101
|
P/n not in s/m - fp262 connects fd-15, vc-67 and fc-28 board | Part number for above is not shown in the service manual.when part is bad, some technicians change the circuit board, not beingaware that this is available separately. | ||
| SONY |
CDX7580
|
Unit has no audio out for am or fm | Unit has no audio out for am or fm, has no seek tuning, alsoin fm stereo, indicator is on all the time. | ||
| SONY |
CDX7560
|
Unit has no audio out for am or fm | Unit has no audio out for am or fm, has no seek tuning, alsoin fm stereo, indicator is on all the time. | ||
| SONY |
CDX7540
|
Unit has no audio out for am or fm | Unit has no audio out for am or fm, has no seek tuning, alsoin fm stereo, indicator is on all the time. | ||
| SONY |
CDX7520
|
Unit has no audio out for am or fm | Unit has no audio out for am or fm, has no seek tuning, alsoin fm stereo, indicator is on all the time. | ||
| SONY |
CDX7580
|
Disk not playing (no laser light) | Disk would spin but wouldn't pick up. found that optic wasdoing focus search but no laser light. ic-1 pin no. 17 had it's 3.7v butcollector had nothing. found base to colector open on q-4. | ||
| SONY |
CDX6020
|
Disk won't play (sled continuously drives to outer position) | When disk was loaded, the optical block would track all theway out to it's outer most point. found sw-631 to be closed at all times. | ||
| SONY |
CDX6020
|
Won't accept cd | Unit won't load cd. first went to ic-1 (mechanism control)pin 33 put disk in, in other words opened up sw-622, and pin had 3.5v,should have had 5v. i then pulled pin 33 and opened up sw-622 and had 5v.therefore, ic-403 was loading ic-1's pin 33 voltage | ||
| SONY |
TAM50
|
Unit will not record | Phone line on unit stays open causing all lines to be busy. | ||
| SONY |
KPR46EX25
|
Unit inoperable, see fpr # m1097 | Set is new and out of box. failed at turn on. replace tran-sistors and they are immediately damaged. | ||
| SONY |
CCDF77
|
Tape path alignment | Tape path entrance and exit out of alignment. | ||
| SONY |
CCDTR6
|
Correct part number of d-953 on the vf41 board | The part number (8-719-400-26) listed on page 225 of theccd-tr6 service manual is incorrect. |