Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY STRAV320
No power No power, b+ 5v short to ground.
SONY TCW320S
Weak tape take-up in deck b - eats tapes Weak tape take-up and deck b pulls tap out.
SONY ITD150
Continuous beeping On hook phone beeps every several seconds. this is caused bystray carbon or other foreign material on board.
SONY CCDTR4
No picture in camera mode No picture in camera mode. checking ccd imager ic i found pin15 (v sub) had 0 volts and q-132 v sub regulator got very hot. foundc-901 shorting v sub to ground.
SONY EVS550
No record or playback video - audio is ok E.e. video is ok. playback video is non-existent and no videorecord. fm audio is ok.
SONY FDL310
No vhf intermittently Customer complaint no vhf and when switched to uhf picturecomes and goes. looks like if tuner block has a bad connection somewhere.
SONY KV8AD10
Set inoperative Set is inoperative. f-602 is open.
SONY CCDF46
Makes clicking noise When camera is on, mechanism goes to loading position. load-ing motor starts chattering. replaced mode switch which did not fix theproblem.
SONY KV32XBR55
Caution removing front bezel Please exercize extreme caution when removing the front bezelon this unit. while doing so, set may tip foward. -hq comments: please add a form of support in front of the crt. this isalso true for model kv-32xbr51.
SONY KV32XBR51
Caution removing front bezel Please exercize extreme caution when removing the front bezelon this unit. while doing so, set may tip foward. -hq comments: please add a form of support in front of crt. this isalso true for model kv-32xbr55.
SONY SLV555UC
Dots superimposed over video on e-e Superimposed on e-e video is a series of white dots across en-tire screen spaced at 1/2 inch intervals vertically and horizontally.if any function is accessed (i.e. channel change, etc.) they will move onscreen display area and return in one second.
SONY KV20EXR10
Buzzing noise, replaced t-602 Customer was complaining about intermittent buzzing. unableto hear in the shop.
SONY STRGX90ES
No output/display blinks "protect mode" Intermittently no output/display blinks unit in protectionmode.
SONY CCDF34
Owners' manual On page 21 of the owners' manual it states that the squaremanual focus symbol will blink when the autofocus function does not workproperly due to low light level or low contrast. this is incorrect thesymbol does not blink. customer had camera in at bur
SONY CCDF33
Owners' manual On page 21 of the owners' manual it states that the squaremanual focus symbol will blink when the autofocus function does not workproperly due to low light level or low contrast. this is incorrect thesymbol does not blink. customer had camera in at bur
SONY KV27XBR10
No sound, no video, no remote functions, replaced ic-301 Receiver had no sound, no video, no remote functions and hi-voltage ok. i found no pulses on data and clock line between associatedics. also, no vertical pulse on pin 29 of ic-301.
SONY KV27TW70
No sound out of speaker, resolder ic-202 n other connections No sound from right speaker, found that one of the leads onthe ic had broken. servicer had two other units serial numbers: 7067498and 7067429 that had no audio out of right speaker. found that vibrationhad broken the lead of the ic on this unit and had
SONY ITA750
No off hook dial in unit When receiver is off hook, unit will not dial out but whenusing speakerphone or on hook dial, unit works fine. credit r. kennedyalso.
SONY SLV676UC
Video blanking in sp mode only When playing back a tape recorded on this machine in the spmode, video blanks out randomly. in cue or review, video is present.with prerecorded sp tapes and sp tapes recorded on other machines itplayed back fine. in ep, playback was normal. sound did
SONY KV27XBR10
No caption memory, replaced ic-1301 Unit would not remember captions. dealer stock unit at independent service. inc-101, 102, 107, 103 changed - no help. changed aboard. did not fix problem. this unit was down a long time.