Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
TCW295
|
Wrong part number - reference no. 315 | The service manual has reference no. 315 listed as a shaft,pulley p/n 3-390-203-01. this is incorrect. | ||
SONY |
WMF2078
|
Missing part number, ref. 905, pcb, tuner flexible | Need the part number for pc board (flexible). see page no.21, reference no. 905 of the service manual. -hq comments: the part number is 1-636-093-11. we will issue a servicebulletin. | ||
SONY |
XE90
|
No power to the amp or no audio | Everything lights up on front panel but no audio. | ||
SONY |
KV27SXR10
|
Insufficient v sweep/severe foldover across screen, c-1548 | Insufficient vertical sweep and severe foldover across thecenter of the screen. most waveforms displayed distortion. by bridgingthis capacitor with another capacitor, the problem cleared. this c-1548was neither shorted or open. | ||
SONY |
KV32XBR70
|
Blanked horizontal lines in picture, replace d1514 and r527 | Picture looks like horizontal lines are being blanked out ran-domly. also heard a high pitched noise from around yoke but yoke is good. | ||
SONY |
XEC500
|
Incompatible replacement part, ic901 | Pin 1 of ic-901 was loading down the 14.2v at the collector ofq-903 to about 6v. ordered ic-901. when i received part, it was noticedthat the ic (lm2904s) had nine pins where the one removed from unit(njm2904l) is an eight pin chip. after consulting w | ||
SONY |
CCDSP9
|
No color in camera picture | No color in picture when using camcorder in the camera mode.the color was good in the vtr mode both in playback and line in record. | ||
SONY |
CDXR66
|
Unit only plays when in vertical position | Unit would not play when in it's normal horizontal position.if unit was in a vertical position, it would operate normally. | ||
SONY |
KV32XBR15
|
No color, replaced x-301 | No color. | ||
SONY |
SPP90
|
Intermittent reception and transmission | Cordless handset won't receive. no talk light when talkbutton is pressed. intermittent in nature. | ||
SONY |
SPP50
|
Intermittent beeping sound | Intermittent beeping sound and batt/stdby lamp is flashing. | ||
SONY |
KV27XBR50
|
No picture, hor. line rolling on screen, ic-500 and r-559 | No picture only one horizontal line rolling on screen. | ||
SONY |
WMD6C
|
Schematic diagram error, c318 | Page 24 identifies a 220uf, 4v cap. at coordinates e-14 asc-138. this cap. is really c-318, and the component layout and parts listare correct. the real c-138 can be found at coordinates c-18 connected topin 5 of ic-102. | ||
SONY |
KV19TS20
|
Set won't tune channels above channel 7, replace d-117 | After set warms up, it would not tune in channels abovechannel 7. | ||
SONY |
SPP90
|
Intermittent operation | Talk light goes out intermittently. hangs up on caller. | ||
SONY |
SPP320
|
No dial tone | No sound on handset. no dial tone when phone off the hook. | ||
SONY |
SPKTR
|
Use in cold environment | It should be noted that the spk-tr is not provided withthermal insulation. | ||
SONY |
WMF2078
|
No sound and opr/battery led doesn't work | No sound and opr/batt led doesn't work. | ||
SONY |
TCFX110
|
Part number of power board | Need part number for the power board. -hq comments: the part number for the power board is a-2056-442-a.it's reference number is 902, and it can be found on page 12 of theservice manual. | ||
SONY |
GV300
|
Loose lcd assembly | The lcd assembly moved loosely on its hinge. found hingeassembly broken. looks like rivet was stressed some time earlier. |