Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KPR46CX25
|
Dead, q601 and q602 shorted, see service bulletin 95r1 | The power supply converters (q-601, q-602) were shorted. thereplacements immediately shorted and r-632 (surge resistor) opened whenpower was applied. | ||
| SONY |
CCDV11
|
Correct p/n for ic-401 | |||
| SONY |
TCW5
|
Will not record; no bias oscillator | The unit would not record. bias oscillator was not running. | ||
| SONY |
SPP100
|
Id numbers on rom ics | The rom id numbers were different in the same package were notthe same id numbers. i will reorder part. -hq comments: the numbers on the rom chips themselves do not indicatethe id code that is written internally. it is a manufacturing code. ifound, a | ||
| SONY |
D11
|
Display window not included with top cabinet | The exploded view on page 24 of the s/m shows the displaywindow as part of the top cabinet (ref. no. 67). this is not the case. | ||
| SONY |
XR350
|
Fm cuts out or fades, fm scan locks up, intermittent | Symptoms include fm cutting out or fading unit locking up infm scan and may be intermittent. | ||
| SONY |
XR7000
|
Fm cuts out or fades, locks up in fm scan, intermittent | Symptoms include fm cutting out or fading unit locking up infm scan and may be intermittent. | ||
| SONY |
MDP700
|
Correct part numbers for woodgrain side plates | |||
| SONY |
STRAV1020
|
Opens 5.15a fuses intermittently - no audio out | Unit came in with all front panel lights lit and no audio.replaced f-852 - 851 unit played for two days and fuses opened again. | ||
| SONY |
CFSD30
|
Dir mechanism malfunction | When playing tape and dir switch is pushed, it sounds like both sides of tape are being played. | ||
| SONY |
CDPC500
|
Will skip on mca "seascapes" discs | Unit will not play mca disc seascapes by michael jones butwould play other manufacturer's discs. this disc is thinner ply thanother discs and you can see through the data. the spindle was not in ahigh enough position to read disc correctly. sounded li | ||
| SONY |
LBTV102
|
Cassette runs fast | Cassette (a) runs too fast. | ||
| SONY |
LBTV102
|
No turntable operation | Turntable socket (cnj-604) loose and not working. | ||
| SONY |
TAM30
|
Intermittent no audio | Intermittently, audio is very low on playback icm. | ||
| SONY |
KV27XBR50
|
Buzzing sound, applied silicon to case of t-602 | Buzzing sound originating from t-602. this was an intermit-tent condition. | ||
| SONY |
SPP170
|
Unit does not work after main board is replaced | The unit does not work after the main board in either thebase or the handset is replaced. -hq comments: the replacement boards have blank id roms. therefore,after replacing either the handset or base unit board, remove the id romsfrom both old boards ( | ||
| SONY |
SPP120
|
Unit does not work after main board is replaced | The unit does not work after the main board in either the baseor the handset is replaced. -hq comments: the replacement boards have blank id roms. therefore,after replacing either the handset or base unit board, remove the id romsfrom both old boards ( | ||
| SONY |
FD2A
|
Tv intermittently no picture, replaced s-151 | Picture comes and goes intermittently. | ||
| SONY |
KV20EXR10
|
Intermittent picture, replaced tuner | After warm-up, flashing noise would appear in picture. ser-vicer was unable to locate bad solder connection in tuner. | ||
| SONY |
SPP115
|
Unit does not work after main board is replaced | The unit does not work after the main board in either the baseor the handset is replaced. -hq comments: the replacement boards have blank id roms. therefore,after replacing either the handset or base unit board, remove the id romsfrom both old boards ( |